Tom,
I have a Kenwood Ts-2000 and ran into a similiar situation a few weeks ago. It turned out that the freq don't update when the radio is in Memory mode. I had recently programmed in all the local repeaters and had it scan them in memory mode. While it is scanning it appears similiar to how yours does. I have the PC light but no updates until I put it back in VFO mode.
Michael, AA5SH
toggle quoted message
Show quoted text
--- In dxlab@..., "Dave AA6YQ" <aa6yq@...> wrote:
What sort of transceiver are you using, Tom? If there's an external
interface between your transceiver and your PC, how is this interface
powered? If the power comes from a serial port modem control signal (like
RTS or DTR), open the Ports tab of Commander's Config window and make sure
that the signal being used as a power supply is set to "always on".
73,
Dave, AA6YQ
-----Original Message-----
From: dxlab@... [mailto:dxlab@...]On Behalf Of
Tom Roberts
Sent: Sunday, November 29, 2009 5:07 PM
To: dxlab@...
Subject: [dxlab] Commander 8.0.5 No Freq - Up Date
Hello to all:
?
My Commander 8.0.5.? LATEST UP GRADES..Stopped updating and
passing FREQ info to DXKeeper ?automatically ..
?
Have not operated since last up-grade until this weekend..
?
Commander will update freq from the XCVR ?Manually VIA the Arrow Buttons on
Commander?or Band Spread Pre Sets?Buttons - However?will not update when the
freq are changed via the XCVR VFO...
?
XCVR is TS-2000 Kenwood..PC Spot on Kenwood screen OK..
?
?
It?has worked flawless for years - - wonderful program
?
?
I have Reset Computer, Reset Commander Con-fig - verified my Comm settings -
no change in operation status..
?
Any one have an idea?
?
?
73, to all..
