开云体育

Hi Rich, When I'm in the shack I usually have something parked on 7023 kHz.? Pretty easy flip of the antenna switch to go between the R-4C/T-4XC and TR-4Cw/RIT so you could get two for one!? Make

That is very common in the TR7. The reason is that the pot does not go to zero ohms until the off position is reached. Later versions seemed to overcome this, likely by a change in the pot. Gary W0DVN

Nice one Steve! Looking good! 73, Jim W7RY

now, there’s something on which you can do some major communicatin’, eh? i love the way the wattmeter and scope are dwarfed... joseph n. graif personal account Sent: Friday, June 24, 2022 12:52 PM

yes...but i don’t know if it’s normal. actually, with a hard to read signal (perhaps it’s psychological), i can copy better with the volume all the way down. go figure... joseph n. graif

Like this one, John? 73 de Steve, NR4M

When turning volume of my TR7 down full ccw I still have audio , in other words, the volume goes down but not to silent, has anyone else experienced this? is it norm? Mark 73

Here's how to do just that: http://www.wb4hfn.com/DRAKE/DrakeArticles/Receiver_Pwr.htm 73, Gary WB6OGD

These are just canoe anchors. A DX100 or a T368 is indeed a boat anchor! :-) Enjoy your Drake! 73 John K5MO jgraif1@...> wrote:

hello, rich and welcome! be careful with that word “boat anchor”. these are our children of whom you speak! my cw is rusty but i have always loved it. contact me directly and we can try setting up

Rich- Enjoy your TR4C; I had one in the past and had many enjoyable QSOs with it over the years.? I hope you do as well. 73, Steve, N4FO

Rich, Welcome to the Drake enthusiasts "club". As to a favored calling frequency, there is a Drake Technical Net that meets at 4 pm Eastern time, Sundays, on 7238 +/- QRM. I'm sure you'll be happy

Good Day all, I'm new here and just wanted to say Hi! I have always wanted an old boat anchor radio since getting first licensed about 20yrs ago. I found an old Drake TR4C at an acceptable price on

I would space from the circlip using 1/4” ID flat washers as needed. Avoiding the front panel is a must! Moving the circlip risks breaking it — they’re pretty brittle but you could try moving it

I figured it out. I thought the C clip was in a grove on the shaft. Its not. I simply moved the C clip out a bit and the wave washer scheme works just fine now. Thanks for the tip! This was an eBay

Thanks. I guess I need another washer between the C clip and the wave washer. The wave washer is not "thick" enough to put pressure on the back of the KHz dial. It just flops around. And it also hits

Jim, the earlier sets use a completely different system. The earlier sets (including the B's) have a single shaft to the PTO, with a single dial for reading frequency to the nearest 25 kHz, with

Hi Who's is able to g?ve info about the coils on the NB4 . Thanks for advice Pierre Andre F6FJH

Is this the same for the R4B as well? Thanks 73, Jim W7RY