开云体育

Hi Paul, The INRAD filter is yours. PayPal as per below. 73, Rob, NC0B Sent: Tuesday, January 23, 2024 9:10 PM To: [email protected] Subject: Re: [DRAKE-RADIO] Misc parts at NC0B's QTH Hi Rob If

You don’t have separate specific band selections in this amp. Those markings are the range over which each particular position will work well. Thus, for example, the 40 meter position covers the

Please don't laugh to my question but I see, on the band knob of my little L75 amp, apart from the basic Ham Bands, the markings 6.5, 10, 16, 24. Those are not selectable. Are those to be enabled my

I am looking to buy a split rear chassis TR-7. Front panel must be excellent. Don't require the NB. Tnx, Dale W4OP

My L75 amp developed a problem on the meter. No longer responds. Have checked it and the signal is reaching it. The internal circuit on the meter is simply open. Have look for replacements but no

Thanks to all responding. ?I found the tool, a new GC brand on Ebay in Pennsylvania, not far away. ?A better understanding of what I was looking for helped much. ?As a side note, I’ve decided to

Hi Rob If the 125 Hz INRAD is not taken, I can take that for my R4C. Paul - W2NMI

I should have said soldering GUN. ?The tip is also excellent for cutting double braided dacron or nylon rope.

I've always used a soldering iron for this type of project. ?There is a "plastic cutting tip" available that has a flattened nose ideally suited for such applications.

I wouldn't bother. The radio waves don't care. Ask anyone in the end-fed half wave crowd. They know how easy it is to make the coax radiate. What you will need is a common mode choke a quarter wave

I have really good luck using a sharp box cutter to first rotate the coax under the knife, pressing hard enough to cut the insulation but not hard enough to cat the braid. Then I cut a lengthwise cut

The DR7 is such a fragile board, a true PITA to work on, I would leave it alone if it works. Those two capacitors are only there to prevent oscillation of the regulator and serve no function in

There is a metal tool used for stripping Romex type wire that ma work well for you. Kind of a narrow clamshell looking thing that is all metal and very reasonably priced Search this on Amazon Gardner

On the page Warren posted, this tool showed up: [ https://www.amazon.com/iCrimp-ICP-240-Stripper-Cables-Radial/dp/B09Q872XW7 |

Something like this would work. stedi Round Cable Stripper, With Adjustable Cutting Depth, for Fast and Precise Jacket Removal Cable Stripper, Round Cable Slitter with Smooth Incision and No Damage to

HI Mike…. Contact your closest electrical contractor and talk to one of their technicians…they have a tool, that is adjustable to remove wire jackets from all sizes of wires. Give him/her a pack

I believe those Rubycon caps are originals. I have seen Richy and Rubcon caps in a lot of Drake gear. Thats is what was in my TR7 when I replaced them 5 years ago. Even back then they had considerable

I would like to put up a vertical sleeved 1/2 wave dipole, using Belden 8279, 75 ohm coax. ?I have been pondering a good way to remove approximately 11 contiguous feet of the outer jacket, of course

Well after goofing around with the voltage regulators connectors I now have display again. Do these yellow electrolytics look newer or are they original? Not sure why the connectors didn't clean

Rob I would like to buy the 4000 AM filter. I have an address in Fort Recovery, Ohio. Nigel Patterson