开云体育

Hi Chuck, It is. -- 73 John?N9FCA

Bill, I know the feeling! I can use a board with the counter section not functioning. The all-band coverage portion does have to work. No hurry. Contact me off list at k9ju@.... Thank you. 73,Bob

Dave, it appears someone lost the original reducer bushing and attempted to use the separator bushing instead. No wonder they stripped it out. The two bushings are not identical. As you can see in my

Chuck Pool - AA5WG Suttons Bay, Michigan 231-668-1115 aa5wg@...

Hi to the group. I am still looking for the extender boards to align the TR7 and R7. Thank you. Chuck - AA5WG

Hi john - N9FCA Is your L-7 low pass circuit still available? Thank you. Chuck - AA5WG

Skip: Don't give up on the xtal just yet. BAKE IT in an oven at close to *375 deg F* ( and NO HIGHER) for 1-2 hours, cool it and try it again. You may find it will work fine, and you've got nothing to

i don't know if mine are OEM, but the measure 4 and 1/8 inches long. The Board that is, and from the tip of the pins to the tip of the socket is 4 and 13/16 inches.? Hope this helps. 73? Bob? K6OXN

Looking for a 14.6 Mhz Xtal for my drake..? its for 3.5-4.0 Mhz... Mine just died.. And NO its not the circuit? I put in a 15.6 and everything worked.. so its a bad Xtal.. Not looking to pay for a

Bob, The DR7 Board has been sitting in storage for almost 10 years if not longer. I don't recall the actual problem. If I decide to take the existing one out and clean the contacts again! For probably

John, sorry it took so long to reply. Busy weekend. The extender boards are sold already. Thanks for the interest. And they were not the OEM. THANKS 73 Bill W4WCS

I need an? 5595 khz if coil for my Atlas 350xl, I know it's not Drake but I thought if I found one it would be of interest to the group. TNX WA4NIZ

I need an? 5595 khz if coil for my Atlas 350xl, I know it's not Drake but I thought if I found one it would be of interest to the group. TNX WA4NIZ

I discovered what I think is an extra low pass circuit from an L-7 I owned years ago. Hopefully someone can use it. -- 73 John?N9FCA

Be very careful of temperature of a stove, especially an electric. Things get way too hot in way too short a period of time! Don't ask how I know. Bob K9JU Maryville, TN

Rick, You might try setting it upside down on an electric hot plate or stove burner.

Well...I have a small metal Vise out in my garage. With that and my 100W soldering iron, it should be a piece of cake, Thanks. 73, Rick - N8XI

Well I have a 100W Soldering Iron that may do the trick, Thanks 73, Rick - N8XI

If the knob isn’t split, try tapping for a larger setscrew. Steve Wedge, W1ES/4 Time flies like an arrow. Fruit flies like a banana. Sent from Proton Mail for iOS

Attached is a picture of my knob and switch. It is not as rusty as the other picture. The shaft does have a flat spot on it and there is a bushing inside the knob. Unfortunately the set screw hole