If the knob isn¡¯t split, try tapping for a larger setscrew.?
Steve Wedge, W1ES/4
Time flies like an arrow. Fruit flies like a banana.
Sent from Proton Mail for iOS
On Sun, Mar 26, 2023 at 14:09, Dave via groups.io <
kc3am@...> wrote:
Attached is a picture of my knob and switch. It is not as rusty as the
other picture.
The shaft does have a flat spot on it and there is a bushing inside the
knob.
Unfortunately the set screw hole does seem to be stripped and will not
tighten.
Dave KC3AM
On 3/20/2023 9:28 PM, Dave via groups.io wrote:
> Hello everyone,
>
> Last summer I picked up a 2-C to go with my 2-NT.
> I have been using it for CW without any troubles.
> I tried to listen to some SSB signals tonight and I found a problem...
>
> I cannot tune in the SSB signals, the mode control just spins around
> and has no effect.
>
> This is the first time I have tried to listen to SSB so this is new to
> me.
>
> Looking at the schematic before I open it up it looks like the mode
> switch should have a few positions to it and not just spin around.
>
> Am I correct?
>
> Thanks much,
>
> Dave KC3AM
>
>
>
>
>
>
