开云体育

Patrick, Thanks for the response. I hooked up my Kenwood TM-V71, and was able to configure that radio to suppress carrier squelch, and accept traffic with ctcss ENC DEC tones. 73. Victor, KB5AKO

Someone correct if I'm wrong, but I don't think the FT-8900 has a way to adjust the logic for that behavior. I have the same problem with a Kenwood TM-D700A. However, I know that some other Yaesu

I can’t get my node to accept only ctcss traffic. It works fine, but it will pass traffic even without a ctcss tone. The FT-8900 is set with ctcss enabled with ENC/DEC. I am using the main band. The

I have used Prompt for years and could not be happier!

I used to use Termius before I retired a couple years ago Did everything I needed. I liked Cathode also, but afaik not available in App Store for a while. [email protected]> wrote:

I’m looking for a free, tried, and proven ssh terminal program that works well with my iPad. My windows terminal works fine, but sometimes it would be real convenient to use my iPad. Any suggestions

Mike: It's been a while, but IIRC, when I set up my TM-D700A as a node radio, in simpleusb, I set the following: PTT: active low COSFROM: USB I also changed the pin sensitivity in the radio, because I

Hi I just received my Dinah USB-C board and for the life of me I cannot figure out the programming (set up) menu for the Kenwood TM-700 Radio to make it work. It is not communicating with Dinah has

Thank you Yes I’m using a TM-700A No ctcss using raspberry pi 3B Will be for Node 61040

Hello Radiotech: If you mean the TM-D700, it works fine with a DINAH out-of-the-box, assuming you want 1200 baud output from the radio, pin 4, not 9600 on pin 5. There is a jumper to change that

Hi guys Looking to hook on a Dinah v4 board onto my tm 700 it should be here any day now. Is there any jumpers I have to cut or add

I’m also, looking for a Dinah board if anybody has an extra one or two they want to part with I’m in British Columbia Canada thank you

Thanks Don. I'll order one. :-)

Make sure which ever of the two systems you choose to use has external data enabled.

Are you referring to the six pin minidin port on the D-710? The DINAH works fine with that supporting the PTT signal. Make sure J3 on the DINAH is open so COS does not disable the sound driver on the

Hi Due to me popping the COM port on my Kenwood D710, I'm only left with the DATA port.? Whilst I don't see an explicit PTT pin on the diagram, I note it is listed as compatible. Can someone confirm

Yes

Is this how you set JP1 to 9600 baud (Pin 4 of 6pin mini din).

Any time, If you have any questions feel free to ask. 73 Mike KB3KAV [email protected]> wrote:

Mike, Can't thank you enough for all of the information... I'm off to spend $$$ :) --- Mike / K5MAP