开云体育

That's the only properly supported way Allstarlink/HamVoIP's SimpleUSB driver does PTT. The DINAH and other interfaces like it just converts that to essentially a continuous volume down press. I

a squelch status indication coming from the radio. Lee K5DAT

I’m not convinced that Direwolf is the problem. The electrical design of DINAH connects the squelch logic signal to the Volume Down pin. For example, this gets used for the volume up and down

We're using the DINAH interface for Direwolf in an APRS appliance for the Appalachian Trail Golden Packet event in an attempt to reduce our reliance on Kenwood APRS radios (specifically the D710).?

So I'm hitting the standard problem in Windows that Pin6 of the DIN is connected to the VOLDN pin on the CM119B in DINAH. This results in the volume being turned down every time the squelch opens on

Speaking of that: Can the TM-G707 be configured to use squelch to drive COS rather than carrier? Somehow, I doubt it. If not, do you know of a hardware mod for either that radio or the TM-D700A to

Recently installed most current version of Hamvoip.? Running on a RPi3b+ with a Dinah and a Kenwood TM-G707.? Everything works great when I use my 2nd G707 and I can see all DTMF being decoded

Confirmed working with my Kenwood TM-G707

Following up on this discussion, I have a DINAH working with a Yaesu FTM-3100R - works fine with either Direwolf or QtSoundModem on VHF packet.? The computer is an Odroid XU4 (arm based) running

I had duplex=1. I changed it to duplex=2 and all is good. Thanks Les. Ted Kingston KB2RCW

I have two Kenwood Repeaters in service Both set to repeat. Both are linked by Allstar. Iset Allstar to duplex =2 in the rpt.conf file. Les Keegan N4LPK

When using a Kenwood TKR-750 repeater, should the actual repeater be set up for duplex, or repeat?? ? And was there a parameter in the Allstar Pi controller to act as full duplex repeater

Thank-you for the quick reply. Lee

If the troubleshooting steps Larry suggested in the previous message do not solve your problem, you can return the DINAH to us and we will fix it for you.? Please email us at kitsforhams@... to

Check solder joints. Look for solder Bridges...transistors, diodes or IC's installed backwards. After that break out the scope or logic analyzer. Trace +5 from the USB to all parts on the board. Trace

Indeed you adjust DINAH sound levels on Raspberry OS using alsamixer. Works fine. As you note, the DINAH is just a USB sound card which can also generate PTT from a sound card GPIO pin.

hi all, i have a kenwood tmv 71, dinah and ASL node... everything was working fine up until two days ago. i can key up the ASL node via Echolink, or another user who is linked to my node can key it

Hello, Currently I'm using an inexpensive USB sound dongle (C-Media) with Direwolf. PTT is handled via the RTS pin on a serial port, which is run through a transistor circuit. The radio (Alinco

Hello, I RX'd my Dinah and assembled it. I am working with a Direwolf group and mine was not digipeating or sending beacons. It is responding to my PTT requests. I have cut JP3 and verified that there

The DINAH 6-pin mini-DIN cable will be directly compatible with transceivers compatible with the SignaLink "SLUSB6PM" 6-pin mini-DIN cable option: See