开云体育

Wow! I been trying to send you that link through out the day! Good! Good for you! Do you have low temp solder used for removing SMD components and the special flux? I will hush if you are experienced

I have regular paste flux, more like waxy ointment really and copper de-soldering braid. I have removed a few SMD resistors before using a doubled over two pronged wire on a soldering iron. The part

This stuff plus the braid. Dab some of the flux from the tube, apply some of this low melt solder on the pads, swish it clean with the braid. Then put a little dome of the low melt on each pad. Hold

I decided to make the swap on my early version QMX which had these caps reversed in position in the instructions. The easiest and safest way is to clip the leads and replace them. Anybody have 270pf

You find any? I just woke up to this...so sorry! I am not getting any notifications on this page!? Need to fix that... Let me know what you need, please! -- 73 Karl KI4ZUQ

Yep- got the caps and made the replacement, and saw no significant difference. 20m was slightly higher and 30m slightly lower but that could just have been from moving the toroids around :) Thanks -

Lead diameter .0185"/0.47 mm nominal -- 73 Karl KI4ZUQ

Need one 1.0 pf ceramic disc capacitor low volts (<15 vdc) with .250"(6.4 mm) or less. Would accept two if you have a bunch but need just one. -- 73 Karl KI4ZUQ

Need one to replace one I broke! Anyone? T37-0 pink -- 73 Karl KI4ZUQ