开云体育

I was trying to get a QMX kit transceiver to work recently and discovered an SMD capacitor missing. Rick, NF6G sent me about five to get me going! He simply taped them to a piece of paper and mailed

All: I bought a QMX at FDIM (#6) but haven't started to build it yet. I'm waiting to get the T41 project done. In the meantime, I have a boatload of SMD caps and resistors if you are missing some.

Making sure I can post Bob

Hi all I have a few spare?1N4148s ... like a few thousand. ?Yours for the asking -- I'll put some in an envelope for you, as many as one postage stamp can carry. Contact me in private email to

Once this gets rolling, Jack, I will bet someone will need at leat one of those 1206 beauties! -- 73 Karl KI4ZUQ

Test sat, 59 and ten over...over! Har, har! -- 73 Karl KI4ZUQ

I got a bunch, too! My little pack is in the group picture. We are SET! -- 73 Karl KI4ZUQ

1nf to 470pf in 0603 size. Will devise a test for any of these you want/need. -- 73 Karl KI4ZUQ

Thanks Karl! Showing up now. Bob EDJ [email protected]> wrote:

Just let me know... Jack, W8TEE

Fresh from China, still on the tape, 47V 1W Zeners, ?. These aren't from my free pile like the 1N4148s, so I'll have to limit all takers to 5 each. Address in private email to jim dot strohm at

Be sure to specify 1N4148s or 1N4148s. That a typo or do I need to learn something? Har, har! -- 73 Karl KI4ZUQ

I meant to say "1N4148s or 1N4756As." Arrrgh. I might have to throw some 6A10s out there to really mix things up. 73 Jim N6OTQ [email protected]> wrote:

I managed to damage R522 on the lower right corner of my QMX while removing the right angle BNC connector. The resistor is labelled 68X or maybe X89 and is 49.9 Ohms. The BNC broke its center pin

Check regular email I sent you this morning but someone on here will have a resistor, I will bet! The BNC may be had from Hans to make sure it fits. -- 73 Karl KI4ZUQ

What sixe is this R522 49.9Ω resistor? -- 73 Karl KI4ZUQ

Hi Karl - The size of the R522 49.9 Ohm SMD resistor on my QMX looks to be about 2mm long. Here is a snapshot of my board. It was only a small corner sheared off (don't ask) so it might still be good

The size of the R522 49.9 Ohm SMD resistor on my QMX looks to be about 2mm long. Here is a snapshot of my board. It was only a small corner sheared off (don't ask) so it might still be good enough...

Please bear with me while I try to figure out this approval system! -- 73 Karl KI4ZUQ

I am now (or will be in 2 weeks) the proud owner of 100 49.9 Ohm SMD resistors for the QMX radio. These are from Amazon, size 402