zbitx - No Tx on WSJTX?
|
This morning I installed the zbitx Image on a uSD card and started it on my sBitx v2 device.
Apart from the hardware difference, the radio control panel started. I tried to configure the wsjt-x program and my experience is the same as yours. The CAT control does not work normally, i.e. nothing happens when I click on CAT.
It is as if the previously non-working version is installed here.
There is also a problem with the RPi clock display, because no matter how much I set the geographical location, it does not show the correct time.
--
Gyula HA3HZ |
|
Please try to remove the Audio tab-> Transmit and Tune selection, it might be interfering.
I searched back in the topic and found timing info in message #101736. The 32-bit version of sbitx uses the same hamlib.
Links to sbitx: /g/BITX20/wiki/30883 /g/BITX20/wiki/34287 Note that I didn't know anything about Debian before summer 2022. If you change anything, always have a previous working backup so you have something to fall back to. I think the others are watching the messages because it doesn't work for them either.
--
Gyula HA3HZ |
|
Still doesn't work? Leo, AI5II On Sun, Apr 6, 2025, 17:25 HA3HZ via <gyula=[email protected]> wrote:
|
|
On Sat, Apr 5, 2025 at 05:39 PM, Leo Aniol, AI5II wrote:
Already did this. Still does not transmit? I'm sorry, but I don't know much about the sbitx application used by zbitx. Why didn't it become zbitx?
Among the questions is sbitx v3, which cannot update v3.051. The name is unfortunate. If you don't read the forum regularly, you will think that v3.051 is a new sbitx version, while this is the firmware version number used by the zbitx hardware. While the manufacturer is shifting the responsibility of providing help to the forum. We are also just users and customers with different knowledge and expertise. --
Gyula HA3HZ |
|
Already did this. Still does not transmit? Leo, AI5II On Sat, Apr 5, 2025, 10:52 HA3HZ via <gyula=[email protected]> wrote:
|
HA3HZ
