开云体育

They are there.... https://github.com/afarhan/sbitx -- Paul Mateer, AA9GG Elan Engineering Corp. www.elanengr.com

I have been looking for the sbitx schematic on github but don’t see it. I don’t see any mention of it on hfsignals yet

Don I agree.? In my temp controller based on ON7EQ's code (see below) I put a real time temperature display on the OLED. If I have not been transmitting then it is simply the shack ambient

Hi Caleb, The download seems to be correct. This is the result on my uBitx. After the download, there is no automatic reset: you must turn the device off and on again. If after doing this it still

I have not been able to make one contact yet on the ubitx v6, tried 2 different antennas, it is receiving good, not sure about the transmit, should I be hearing a relay kicking in, tx light comes on

Thank you Gerald. You could knock me down with a feather - it actually works. Connecting the input to a known 144 Mhz antenna gave 1:1 SWR. I then tried it with my G5RV with an? MFJ automatic tuner,

I finally got the Raduino32 put in the rig. Trying to flash it to work. Only getting fully white screen. Below is the COM port out from the USB port. Just repeats over and over. I flashed the

While I’ve also used dd for this, BalenaEtcher works great on the Mac as well. -- Buddy Brannan, KB5ELV - Erie, PA Email: buddy@... Mobile: (814) 431-0962

It's the native file format for Open Office, which is a pretty good substitute for Microsoft 365 with one exception: it's free. Jack, W8TEE

And Microsoft Word should read it just fine too...

An .odt file is an _O_pen _D_ocument _T_ext file.? The program that will read it is Libre Office.? This is a free program, almost identical to Microsoft Office.??? It is available for Linux,

... as above, balenaEtcher is the way to go if you have a PC, makes the process very simple.

With great power comes great responsibility. (Thats why I am a QRPer...)

Ashhar Farhan wrote:

I am a bit of a n00b with all these software. I just prefer using the dd command to burn the sd cards. The details of using the dd command are all over the internet. - f

Al - WA1CZG wrote: Hi Al, ???????? I used balenaEtcher to write to a Toshiba 32bit SD card, runs fine on my Pi 4, really nice of Ashhar to put the circuit of the sBitx as desktop back ground

Ashhar, I downloaded the image and tried to burn it to a 32gb mini card. After I formatted it with the Raspberry utility I got a capacity of 31.3GB. When I try to burn it I get? message that I need

LibreOffice <https://www.avast.com/sig-email?utm_medium=email&utm_source=link&utm_campaign=sig-email&utm_content=webmail&utm_term=icon> Virus-free. www.avast.com

Open an odt file with either LibreOffice or OpenOffice. Both are open source and are a free download, run on MSWindows, Linux, or MacOSX A quick google search for "odt file" says this in the first

What program reads an .odt file! Thanks, Roy WA0YMH