开云体育

I read what you wrote and that was why I responded the way I did. If you look at the new chip with a magnifying glass or lope your B may look closer to an 8, I don’t ever recall see a IC by National

Today the Chip arrived, but found that it was the wrong type, this was the numberEM11G LM3B6N-1 . But tried it anyway, is it normal that the loudspeaker came out a lot of noise at 9 volts . No display

Great information and a clearer understanding of the available paths. Teensy has interested me for some time and will likely go that route. Thanks everyone - I appreciate the help 73 Mark - WB1FCG

Mark, As Jim, W0EB, accurately stated, there is not much room in processing resources with the single, stock Nano.? It takes almost ALL of them for either the v6 stock graphic display or the KD8CEC

Mark You would have to ask K8CEC about any forks to support different type displays using his code.. There are many different displays available, some inexpensive and some not inexpensive.

That's amazing and my type of cheap project . 73 Owen

SOLD. Thanks for viewing.

Yes because you bought a nextion display!

I am using the CEC firmware and Nextion screen and it runs perfectly well. There is no noticeable delay as far as I can see. Reg?????????????????? G4NFR

Still have it? I’ll take it. Let me know off the list your PayPal address and I’ll send funds immediately. Jim, W0EB

The CEC software wouldn’t be any better with the ILI9341 display than the factory as the NANO is just too slow for color Touch screens. ?Reed’s version speeds it up slightly but all the excess

Hello Earl, try to go in the home page ( https://amateurradiokits.in/home/ ) and after go in Store and you?search and click "General Kits" the AGC is the "AGC KIT For Bite And uBitx" is the first

Hello: Reed BN has a version of firmware for Ubitx V6. He can be email at: <greenkid336600@...>: His firmware can be downloaded from: https://github.com/reedbn/ubitxv6 Documentation can be

https://www.homemadetools.net/forum/smd-reflow-soldering-gif-86780?utm_source=newsletter&utm_medium=email&utm_campaign=08-18-21&utm_content=08-18-21-186591&fi=186591#post186591

*Selling 4 month old uBitx 6 kit built and tested* I built (simple construction) this unit and used it in Berkeley, California to over the summer to test out its capabilities. Using a 20 meter dipole

?https://amateurradiokits.in/product/agc-kit-for-bitx-and-ubitx/? When I downloaded it then tried to run it my antivirus spoke up as mentioned. Earl Cox? KB5UEW?Reply or E-mail me at:?

I received the new uBitx v6 earlier this week and have been enjoying the new toy. Nice little radio Ashhar and HFSignals. I started looking at the suggested mods/updates and began work on the AGC one

I specify as stated on the site. THE ASSEMBLY DOES NOT GIVE GOOD RESULTS. It becomes a base of work to do again. So work with KICAD and made a new PCB. good luck

hello, here AMP Lab at Virginia Tech - uBitx Workshop (google.com) ( https://sites.google.com/a/vt.edu/amp_lab/projects/ubitx-workshop ) on the bottom of the link this is the only kicad project I

Hello Earl What link exactly ??? I have tested my file with antimalware and Microsoft defender, no problem. cdt