开云体育

Check to see if you have a cw sidetone. If you don't have a key, at least carefully put a wire across the key interface. I suggest this as a way to verify receive audio is okay. Gently tap on your TR

Ed Thanks for your suggestions. I just did the calibration and BFO again. No change. The problem there is that I can not receive any stations to hear. I heard a tone around 10 mhz. very weakly. Could

Try and free up as much memory as you can in the editor. Maybe compress the images a little. The graphs take a lot of memory so if they enhanced that part of the editor in later versions I can see you

Doug I’d go thru the setup on the receive side, BFO and SSB, most likely you are receiving dead air between bands, that’s the only thing that comes to mind. Check some of the V5 setup files on the

I'm using an old Atx Ps 12 volts.?Just a suggestion?Don't know how noisy it is electrically.RegardsOwen Vk5fkol?Sent from my SAMSUNG Galaxy S7 on the Telstra Mobile Network

Hi I have a question I hope someone can help me with. I assembled a Ubitx V.5, and everything seems to work except no receive. It transmits cw and? mic. If I hook another transceiver to another

I have been a little sick and the tuner isn’t here yet. I will try in an hour or so.. Chris

Thank you evan. That did it. I downloaded the LTS version and everything is working like a charm.

Many thanks ? ?? Tried your suggestion,? alignment screen comes up but still no response to conrtols other than volume. ???? Dave c?????? GW0NVF

Everything is fixable Ralph. The first thing I would check the tools menu.? You have nano selected under the tools/board tab and when you click on tools/board info you get a window come back that

Dave, first Dave, power off the unit. Then while holding the encoder switch pushed in, power up the ubitx. You should go into the TFT screen calibration. Once that is done you should be good to go.

I got curious and checked on the Nextion web page.? Seems there is a new version and an LTS version.? You might want to try the LTS version to see if that one can compile the 2.8 files.

Is there a way to get older versions of the nextion manager? I did noticed that it said that the file was created under an older version.

That is just the same project that I am working on, Kit from eBay.

After building the uBITX 5 I needed something to house the little electret mic cartridge that came with the kit. I had an old D-104 with a dead element hanging around, so I decided to use that. I get

If you go to Ashhar's git hub site and see from the filename that it is an updated version for a version 6 transceiver just download it to you desktop as an example. Then open the Arduino IDE GUI

This might help: https://www.youtube.com/watch?v=3n_V3prSJ_E&feature=youtu.be 73 Evan AC9TU

Thanks Andy, that is helpful.? What I was looking for was instructions on how to apply the latest version to my uBITX.? Do I need specific software (IDE?) or am I just downloading the file, and

GigaParts has the uBITX V6 full kit for $209.? That includes shipping.? I purchased one and it came quickly.? Its firmware is version 6,1. Vic, W9RGB

Rene Some thoughts that may help. 1? As Mark says, 800mA without modulation sounds about right, you will be able to detect some residual carrier (carrier leakage) on a nearby receiver.? This will