开云体育

Randy I am thinking the rig will not make much noise into a dummy load - the gain is purposely low.? So do try your normal antenna, and try headphones as well as speaker.? As delivered the BFO may

Just finished wiring? up my Ubitx V5 this morning and connected a dummy load. It had a quiet shhh sound and when I turned on the volume I could hear noise that got louder as I turned it up. I did

Kit building is all about the adventure and the accomplishment when finally complete....LOL

Use double sided tape, on a flat wooden base the wood will be milled with the panel depth. Clap the wood on each side. I mill sheet metl like that all the time. <laddie2@...> wrote:

Awesome...congrats! Yeah.... Agree with Laurence. Get a feel for it before u build the s-meter.

Thanks again. Now I have to modify the case to fit this beautiful display. Time to take it apart and mill the front panel, I just have to figure out how to mount it in my Bridgeport. I'll send a photo

When ready http://www.hamskey.com/2018/05/creating-simple-s-meter-sensor-for-ubitx.html <oberman.l@...> wrote:

Dont worry about the S meter for now. Just use what you have and get used to it for a couple weeks. Its very simple, uses the available arduino line, does not need another nano. Very simple circuit.

Holey cow it works, thank you, thank you, thank you! I guess the next question is how to install the S meter circuit? I have an arduino uno in hand.

Laddie, You shouldn't be trying to install an hmi file to the rig. The nextion tuns on the tft and the nano on the raduino runs on thd ubit firmware...should be a hex file. I'm home and can sit at my

In case you dont have xloader http://www.hobbytronics.co.uk/arduino-xloader <oberman.l@...> wrote:

I will send you a file, then you have to to use xloader on Windows or use the script I provided for Linux to send it to the Ubitx Raduino. Here are the two HEX files, UBITX_CEC_V1.100_NX.hex

what is this "Then the correct firmware for the Ubitx." and how is it done?

I FINISHED MY VER 5.1 AND IT IS WORKING VERY WELL. I DRIVE THE SPEAKER WITH NO AMP OTHER THAN THE 386 FROM THE RIG. PLENTY OF VOLUME. I ADDED? AGC BOARD FROM SUNIL. FOUND A S-METER ON EBAY (CB METER)

Hello Which HMI file. There are only two files. The correct firmware for the Nextion display whihc it seems you have already loaded. Then the correct firmware for the Ubitx. That's it. No reason for

Dave interesting stories there about ancient and modern coexisting.? here in US our feds got wild idea to put too many jobs in its vicinity.? no matter how much roadbuilding gets done, it isn't

Yes it was working with the original display. I am trying to install the HMI file using nextion editor but it keeps failing. I have a usb cable from my computer to the arduino port.

Dave, The uBitx is good for what it is, a working starting point with which to experiment. Some bands and modes may not meet regs so not a good idea to add a linear amp for high power. Comes mostly

Remove the SD card, Ensure the Ubitx has the Nextion firmware and then its should work. Was this working before on the original LCD that can with the Ubitx The V5 has newer firmware

OK new sd card and it........................LOADED! HOOORAY.! Now the beautiful screen shows up on startup but is-int operating. What is next?