开云体育

First I really like the newest version, saving the mode is a big plus in my opinion. As long as we are discussing writing frequencies to memory, from my viewpoint I don't see the purpose of writing it

I looked at the output of the Synthesizer today where it enters the Bitx board with a scope and on mine the output went up as the current increased. I didn't measure anything exactly but it appeared

I missed tonight didn't think anyone was on. How about we do something at a specific time say Sunday night @ 1:00 UTC??Steve Greer you up for running net logger again? If so what time works? I'll

Loud static :-( sounds almost like a smps that's given up the ghost

No other receiver is available :( and the static only gets louder during sweeping no tone. just static and louder static.

Sorry, Allard. I keep forgetting that I'm using a Mega but most are using a Nano...my bad. Jack, W8TEE To: [email protected] Sent: Thursday, April 27, 2017 5:10 PM Subject: Re: [BITX20]

I heard KC2NUD calling cq shortly after 8pm, he did not hear me. Later I heard KC2NUD talking to W5IFN and hoped to get a relay but W5IFN was in a hurry to go.? Bands were OK, not great. I am trying

Hi, Break up your trouble shooting (Simplify). Dis-Connect Xmit DC Connector and just get receiver going. Dis-connect mic and ptt. Put the speaker connector directly to a speaker or headphones.

It seems to me that the CLK output is set in mA - the following stage being a high-impedance (common emitter) buffer, so CLK output changes in current might not be reflected in the voltage without a

Greetings I have about run out of gas. I have tried everything I can think of. My BitX 40 will not work. I have tried everything I can think of with no real success and I am at a total loss as to

Thanks Cory, that's a good idea that we can easily implement. It will help to reduce the number of unnecessary write cycles. I'll put this one on my list! 73, Allard PE1NWL

I have just finished building the VK3YE LED-LDR AGC circuit, for an MST-Mk1 (not BiTx40), but a similar rig. ?Write-up and demo video

I have also fiddled around with si5351 power output levels with unconvincing results. I am.not able to access my gear for afree days, can anyone else verify this?

If the frequency hasn't changed for 10 or 20 secs then save it. Would prevent writing to eeprom while tuning around.

it only needs a few milliseconds.. S

I agree with Jerry's point to keep it simple. For now I'll stick to the current concept but increase the write interval to 30 seconds. We can always add extra features such as "favourite frequencies"

Would a Supercap have enough juice for a write? I have no clue. Jack, W8TEE To: [email protected] Sent: Thursday, April 27, 2017 4:10 PM Subject: Re: [BITX20] raduino_v1.08 released I

My primary suggestion is to keep it simple. ?The easier this baseline code is to understand the more people will be able to hack in their preferences. ?And learn a little bit of programming in the

Ah, it was just to be amusing.. BUT maybe someone felt like playing with two resistors on a spare input pin??? I am too busy climbing radio towers, and 200 other projects.. Likely the existing

How about tonight? What time and can we do a jt65 time as well?