开云体育

Dear Members, I am getting back in the game with a new all band Ubitx v6. In preparation of trying to put a NX display on it, I was learning how to download and program a Arduino NANO and see

I'm happy to report it was the encoder.? I purchased this I linked from eBay and replaced it and it's working beautifully.? Now on to getting everything tuned up.? ?

Power off radio, press the button in, then power up...

I can't enter setup mode even if I?try below.??firmware V6.31 why? * Power off radio * Power on radio * Press and hold tuning button for 10 seconds (or until menu comes up)

Jonathan Nice work getting used to a nice spectrum analyzer. And doing some calculations. Keep in mind the bandwidth at the receive output is about 3 kHz. I suggest starting near the back of

Here is a capture of the (de)modulator from the spectrum analyzer. I Injected a 14 MHz sine at -60 dBm. On the uBitx v6 schematic this would be at TP20. Again, turning on or off the function generator

Okay, so I went through and recorded the gains and losses of each section. I did this because my RF mentor said that I should be able to easily hear a -90 dBm signal. Unfortunately this was a bit of

I assume you've checked carefully for solder bridges on those connections. There's very little room, and no dedicated thru-holes for those connections. Are you open to an off-the-wall suggestion?

Afternoon brad, Yes the connection is to the volume pot on the front of the board. The high side is the end that comes from the radio to the audio chain. So it would be the input to the

So I have double checked my connections and I have verified that if I switch the LED connector the LED will change from red to green when i hit the PTT. But I still cannot get it to light up when in

I recieved my kit-projects AGC kit this week and am working on the install today.? When reading the install instructions there is mention of a volume pot connection. How do it determine what side is

Hi Joel, Yes they are. That is all we are selling now. However if all you want to do is add a Teensy 4.0, the adapter fits the Factory's Raduino just fine. If you need a replacement or want a spare

Jim, Are the new Raduino replacement boards that fit the V6 cabinets ready yet? Joel N6ALT

The short answer is no, unless the discone you have can work down to 28 MHz, as that is the hugest band? that the ubitx can operate on. Note:? You do need an amateur radio license for this radio,

I would agree with what you are saying based on the v5 that I have.? I did not need to add the outboard amp as I had plenty of sound from the speaker.? However I still run the volume almost maxed

Russ, You are finding out what a lot of us are finding, that the volume needs to wide open to hear anything. I am going to install a preamp to the audio section and will report back as to how it

Hi Evan, I used a 5 watt amp, ( the one included in Sunils case), hooked directly to the output of my V4 and it works great, plenty of audio. I have used a lot of LM386's in my day and they are

Hi Raj, I use a dipole on 40 meters and a EFHW on 20 meters. Joel N6ALT

Richard, there is a menu setting to select straight key or keyer mode.

Found Reeds code in github and uploaded it. It's ok, but CW starts slowly and the offset stays :D Well, made some qsos and learning to use this. Perhaps soon in bushes .. Juha OH8CW