开云体育

Farhan, the link by Bill works fine. Same page I think!

oh, holy smoke of rosin! the images didnt make it through, later tonight... 73, f

ok, here it is - f wrote:

Nope...not going to risk the HF rig at all. Five days and we're no closer to finding out anything except I bought junk. I appreciate the help from everyone...especially Gordon. You spent a lot of time

Simply couldn't resist haywiring the board and trying it out after getting it today! Despite the precautions about trimming leads, I left them untrimmed and all worked well! Photo enclosed...

Well thanks to your local Postal Service too for the DHL delivery of UBITX. Sure was a pleasant surprise! I still remember the agony of waiting for the BITX40 lat year. 73 Bill W6SDI

I can't. He says that has to be working to go on. It's not.

Hearing it over the time signal is why it is being suggested that you disconnect the dipole from your main rig and temporarily replace it with a short wire. You won't harm the Yaesu at he power

Follow it through with the video. You will isolate the problem(s). Its almost fool-proof. Make a list and we can help you fix the problem areas. Dr. William J. Schmidt - K9HZ J68HZ 8P6HK ZF2HZ

Or perhaps this one? https://web.archive.org/web/20111018093646/http://w7zoi.net/lpf-expts/lpf-expts.html

I just tried to start the troubleshooting video. First, it's outdated. Second, touching the antenna with a wire caused it to pop and crackle until I put it firm, but I didn't get increased

Correction. PTT does nothing but the encoder button only exits the menu. The change to CW tone does not take. Regards Simon VK3ELH

If it's at 5000, I'll never hear it. That stupid time station is way too loud. I have tried it though with the plugs still in....only unplugging it from the LCD so I could raise it up. Still didn't

See picture for paddle wiring. Dot to ring dah to tip. With code changes could be used for a straight key also assuming it has a mono plug. Read A6 at start up. If 5v run paddle code. If 1.6v run

A dipole. Not going to change anything on it though. Not going to risk my HF rig over it. But, if I can hear the frequencies when we force it to a frequency, I should be able to hear it when it's

actually, that pic shows 5 caps and 2 resistors. I suugest that it would be useful in these posts if you refer to components by their numbers on the pcb, for example C1, C6 or C5 for those closest to

Caps look fine to me. The two resistors can't really be seen from the at view, as far as the solder joins closest to the Si5153 are concerned but I would suspect that they are also OK.

When you have the raduino out of the case, is the display no longer connected? If you have it connected and tune to a freq, then disconnect it that freq is lost unless the tuning pot is coming with

I noticed mine got here fast, thank you Ash. Joel N6ALT

Nothing obviously awry there.