开云体育

I am building up my own external BPF's for 80/40/20. I need to coat the windings to hold them in place. Can I use a spray clear coat? Will it affect the inductance? 73 Ken VA3ABN

This is where i get mine, http://www.thepartsplace.k5nwa.com/index.php?route=product/category&path=68 Joel KB6QVI

The usual suspects: Mouser, Digikey, Farnell, and Jameco. Todd K7TFC BITX20@...> wrote:

What is a good source in the US for a ceramic resonator?

Hi Colleagues Please, can someone have available this interview? -Ashhar Farhan was interviewed for a CNN report (08-May-05, 20:00 UTC) on the Amateur Radio contribution to the Asian Tsunami

Microwave that tap washer alongside a glass of water. A microwave oven needs something to absorb all that energy. I once tried microwaving half the recommended amount of popcorn. The magnetron

VU2DEV was also trying as to use a carbon Pot with link below, a couple of weeks ago. http://hamrmipl.blogspot.in/p/ddsdirect-digital-synthesizer-using.html?m=1 Also got codes for 20 Meter for above

It could definitely be annoying if the tuning rate isn't set to your preferences. I used symbolic constants (e.g., #define INCREMENT) to set the increment and the time delay in the code before the

Ha haa, that's true Todd :D Pardon, bit off topic ;) Jerry, I used kind of this

The encoder with variable increment step could be made to work well. On the other hand, I have a Tecsun consumer radio that does that and it annoys me no end how it more or less arbitrarily flips

Jerry: See my earlier post (19785Re: [BITX20] tuning step size) on the 26th about using the spin rate of the encoder?shaft to automatically change the increment step. Jack, W8TEE To:

Jerry I had switched my vfo to a DDS, so I have no experience with the pot as an encoder. I did find my volume very scratchy and switched to a new audio taper pot. 73 Ken

Because the fun is in the inventing, not just owning, the wheel. ;-). 73, Todd K7TFC

Possibly from oscillator of Arduino? Or if the LCD has an LED back light. I have noticed LEDs that light up my microphone buttons do this. Regards Dave G4UFS

Hi, BITX40 and Arduino connected. LCD 16x2 and rotary encoder. Notice there are some birdies at approx 50Khz distance. Anybody noticed this also and know the root cause? Ron - PA3FAT

Anybody having trouble with noisy pots on their Bitx? I'm happy with the volume controls on the consumer gear I have, I assume they are all carbon. Though after years of use, they can get

Thanks, Ron, Good information! Roy WA0YMH [BITX20]" <BITX20@...> wrote:

You get tracking number when paypall notifies on shipment. You can use India Post tracker (aftership). Probably when it arrives at your country you local carrier will address new one. Could at least

Can anyone that's already received a BITX40 tell me if you get any emails that confirm when the order is shipped or even maybe a tracking number? Or is it just a surprise when it shows up? Thanks,

Hai all The BITX40 board arrived intact and connected and put in a neat metallic cabinet. Rx is working excellently well. Unfortunately the Tx is yet to perform as prescribed. The PA is drawing only