开云体育

One piece - ready made... BNC Female Chassis Mount Connector - Square | | | | | | | | | | | BNC Female Chassis Mount Connector - Square 1 Piece | Female | Nickel Plated | Crimp Type | Chassis Mount |

Tom I looked at what it might take to make a D-hole punch. Seems that a 1/2 inch Grade-8 bolt could be turned to the desired diameter and one side ground flat to make the D part. Then turn the end

there are some creaky bones like us who are stull puffing the ol bitx20. this way before this city came up here. we'd hunt 'em nylon tap washers and cook 20 meters on nights of 2009 cycle. - f

Arv, I've considered making my own. I have a drill press and an arbor press. I've got a good set of greenlee hole punches (the bolt driven punches) but none that are d hole or that small (I think my

Mute This Topic: /mt/75262023/234805 It’s good to use the tools attached to the email where you complain about how to mute a topic.... Rofl

Perfect practical approach. [email protected]> wrote:

If you have a machinist friend it would be fairly easy for him/her to make a D-hole Punch for thin aluminum plate. Remember old bolt- driven chassis punches. Same thing works for punching D-holes. Arv

I make my own from scrap aluminum sheet. They have a regular hole in the center instead of a d-hole but as long as the?BNC?connector has a lock washer and is tightened down properly I have never had

Does anyone know of a source for these? I used to buy these from Oak Hills Research, however with Marshal Em's passing you can not order from OHR. It is just a plate with 4 screw holes spaced to match

The original poster is asking about his BITX20, not the ?BITX.? Farhan released the ?BITX design in early 2017.? It was first available commercially through HF Signals at the end of 2017.? His

Rajesh, First off, did you follow the suggestions in this message? /g/BITX20/message/80271 NOTE: Please ignore the typo Arduion, it should have been Arduino. There is only one file

Thank you Vic!? I did not know that was there.? I will need to give it a try. 73 Evan AC9TU

Hi, I looked around for the means to mute message threads by subject on groups.io. We apparently cannot do that but there is a hint that we *can* mute messages by their hashtags. I have added a

Evan, the CEC firmware allows WSPR in beacon mode for transmitting, but not decoding. You use the Memory Manager program to set your location (you can set 4 different locations), and frequency (3

Hi Thanks for the revert. I use the standard lcd display which comes with the box. Have uploadrd the corresponding hex files as well. But still the display does not light up. Since I have ver3 running

Possibly one of the mixer diodes is in backwards. The original BITX20 had a very sensitive receiver, which allowed spurious signals to be heard if there was no RF input and if the volume was turned up

Hello Rajesh.... If you have taken the raduino out and replaced it various times, I'd double check to make sure one of the connecting pins has not missed it's target hole and is folded back where it

I'm not trying to be funny but... If it were me, I'd get a V6 and look at that original version as some replacement parts. I know you are determined to make that work but consider the operating time

I searched for the same more out of curiosity than anything. While there are some at near the same price but they only do one band, for the most part. I wanted the range of features the V6 has so I

Steven, Not sure that I can help. however, I could interpret that you have had WSPR running on just the uBITX Nano with the CEC software.? I was not aware of that.? Would you please point me to the