开云体育

At $3.92, it looks like a good deal to me. Have to have a hole in the receiving chassis/panel same size as for an SO-239 but if the mounting flange is to be located behind the mounting surface, a hole

If you chose to go the drill route, I highly recommend a 'step drill' for thin sheet metal. Regular twist drills have a nasty tendency to grab and send the maretial spinning. If your hands survive the

Hi, I have used some of the chassis mount BNCs as shown here. I have used plan A and installed 'hole mount' BNCs with the lockwasher and tightened them enough to hold. I have also used plan B and

You can also form a kind of D-shaped hole by using a center punch and mashing out the edge of the hole with a series of three holes or so at one point, squeezing out the hole to fit the socket. Or,

Harbor Freight used to sell a Deep Throat Metal Punch which would make an easy job of this. I have one but they no longer offer this hand tool. It can be done with a drill press but safety precautions

Thanks Evan, Will try to sort it out. Shall keep you posted when that happens. Rajesh VU3RHU

Hi Chris, I can see that option at bottom of the the messages in my email client. Our neighbor with the problem is not using an email but reading the messages on the groups dot io site. I went there

For your conversion consideration, BNC female panel mount with 0.72" holes on center are not common but do exist. https://www.rfparts.com/connectors/connectors-bnc/bnc-panelpcb/rfb1115-14.html Rgds,

Yes, find the resistor to the LED that provides the driving current for the lighting, and then increase its resistance.

Hello, I was wondering if there was anyway to control the brightness of the uBitX V6's screen? - Mike

So, start with the basics. Read the voltage on the push to talk pin of the jack, and see what happens to it when you plug that mic in. If it goes to zero, you are shorting it out somehow. Proceed

just got my uBitx V6 assembled, been listening to the receiver on 40m ,it seem to be OK.? decided to check transmitter out, when I plug in the Baofeng mic the radio goes into transmit. after doing

One piece - ready made... BNC Female Chassis Mount Connector - Square | | | | | | | | | | | BNC Female Chassis Mount Connector - Square 1 Piece | Female | Nickel Plated | Crimp Type | Chassis Mount |

Tom I looked at what it might take to make a D-hole punch. Seems that a 1/2 inch Grade-8 bolt could be turned to the desired diameter and one side ground flat to make the D part. Then turn the end

there are some creaky bones like us who are stull puffing the ol bitx20. this way before this city came up here. we'd hunt 'em nylon tap washers and cook 20 meters on nights of 2009 cycle. - f

Arv, I've considered making my own. I have a drill press and an arbor press. I've got a good set of greenlee hole punches (the bolt driven punches) but none that are d hole or that small (I think my

Mute This Topic: /mt/75262023/234805 It’s good to use the tools attached to the email where you complain about how to mute a topic.... Rofl

Perfect practical approach. [email protected]> wrote:

If you have a machinist friend it would be fairly easy for him/her to make a D-hole Punch for thin aluminum plate. Remember old bolt- driven chassis punches. Same thing works for punching D-holes. Arv

I make my own from scrap aluminum sheet. They have a regular hole in the center instead of a d-hole but as long as the?BNC?connector has a lock washer and is tightened down properly I have never had