开云体育

I like the upgraded display. I assume I will be able to upgrade my v5. Will the new sketch allow boards earlier than v5 add the display? Dale -- Dale Hardin Elberta, AL

Hi! I need a recipe for calibrating my ubitx. What i got: - uBITX! - uBITX Manager - latest CEC firmware - dummy load - SDR receiver (FunCube Dongle Pro +) - poor antenna (long wire for 40m band) -?I

To paraphrase Heathkit "We won't let you Solder''

Impressive upgrade. Amazing you were able to squeeze this into the Nano processor. I'll try the upgrade to this new display on my older uBitx. Tom, wb6b

No, you will need to go into transmit mode.? Unless you have a dummy load, I would disconnect the power from the finals (the brown wire on the 3 wire connector for power to the board).? That way you

Thank you Farhan. I just received and wired ubitx5.. and now ordered a new one :) Looking forward.

Whoops, I meant www.robu.in (for indian buyers) 73, f [email protected]> wrote:

Anthony, you can easily upgrade to the tft display. It costs about Rs.600 from www.robu.ib

Thank you Farhan Sir.? Now we know what was brewing at HF Signals. I just completed my homebrewing of V5 ubitx from scratch, looks like time to go back to my bench again :)? I would love to come

People, Here is what it looks like : https://www.youtube.com/watch?v=XdnXn5oibpg And of course, yoiu can buy it on hfsignals.com. The shipping will happen from Tuesday onwards. We have a limited

Pat, The last one (Bitx40 I built a few months back) I had put the display connection in on the wrong set of pins, a common issue with the current instructions. I would check to make sure its in the

Hans, Even 25 ma idle current should be enough, given that it is a push pull amplifier and a large part of the power cycle keeps one or the other transistor switched on. - f wrote:

Hi all Changing amplifier class is firstly a matter of altering the idle current. It requires an increase in bias to increase the idle current (NOT a decrease in bias). That is the first thing to try.

Don, In RX mode, relay K1 is not providing 12v to the TX power rail, so transistors? Q911,Q912, Q92, Q93, Q96 and Q97 are not powered up. I suggest you disconnect PA-PWR from your power supply so the

Evan - for testing the transistors, do I have the board in normal RX mode?

Two ways to go forward at this time: 1 - Measure the bias voltages on the transistors 2 - Remove the transistors and do typical diode check on each junction I would do the bias voltage checks. You are

I may get a scope next week. Of course I have? no idea how to use it, but my guru (Dan, W3BU) has kindly agreed to some brief training. I have a DVM and lots of stick-2-it-tivness.? So they are my

Evan and Co.? I opened RV1 all the way and that gave me a small momentary deflection of power meter.? But essentially RV1 setting doesn't appear to be the problem. Here is a short vid of RV1 full

I checked the IRF510 traces per diagram -- red checks indicate continuity with appropriate PA pin.? Looks okay? I now see why a shorted Q94 made the rig short the power supply on TX -- the Source pin

I got IFR510 from someplace. I can't track the order history. But using a simple set of DVM-based tests they check out for on/off state. I know that says nothing about the actual performance on the