开云体育

I'm sorry, but the unit is sold. Jack, W8TEE

All: The BIX40 is sold. Thanks for the interest! Jack, W8TEE

Still for sale?? ?I have a friend who is interested if he can reach you or find your paypal address.

Oops. Not all in same folder. Works now. Now I have no audio. It never ends. [email protected]> wrote:

Do you have all of the source code files in the same directory? Jack, W8TEE

Still no success. Also, ubitx_v5.1 won’t compile. Get si5351lbx_setfreq was not declared in this scope at si5351lbx_setfreq(0, usbCarrier) Also had to comment out checkCAT(); for the same not

Jack, have $$. But no PayPal acct. Workable? [email protected]> wrote:

I have a BITX 40 (V3, #270) for sale, still in its original shipping box. I already have 2 units built and know I won't have time to do this one. The price is $50 and that includes shipping to CONUS.

Yes sometimes seeing can be the issue! Better to use an ohmmeter (DVM or other type) to see if there is continuity from 'ground connections on the board - any, they are all connected within the board)

It has been awhile, but to the best of my memory it was less than 2 minutes. 73 Evan AC9TU

How long should it take to upload?

Hi Gavin. I don't see a RF ground.?The (-)DC voltage is not a ground.? On most power supplies it is a common.? If connected to ground at the supply, it is connected to mains electrical system

Hello, in the file folder i put the v07 and v08 HEX files /g/BITX20/files/Signal%20Analyzer%20HEX%20files.zip 73s

Hello Group, long time lingerer, first time poster. I've had the uBitx V4 for almost a year now, and have used it for listening a bit, but not much. Recently I met a local ham (VE7PS) that really got

Please be sure to use the correct hex file, there are a number of them. Here is the FileNameInfo.txt listed.? Note that the hex file to use is dependent on the display that you will connect.? The

Did you remove the paint from all of the holes to insure good contact? Antenna jack, power, board mounting holes, jacks, case screws,etc. Twist your audio wiring together more as well.

Thanks Evan, I have downloaded the most current files (that you listed) and have uploaded first the sketches and then the hex files to see if there was any difference. The radio loses volume after

I did look at the nextion ? command set dim and dims, but will the in completely reduce the nextion noise

There are two system variables to control the dim function: 1. dim = 0? -> 0 = off. After reset you must set this again. 2. dims = 0 This will also work after reset.

Use a 2wire + shield cable between audio 8 pin plug and the volume control. The ground pin of VC can return back on the shield wire to the connector. But not to be grounded there at VC. Hope this