开云体育

ok got that but what is thesmd cap for terry

hi i have a mini usb cable but it does not easily go into the raduino socket. are there different types of mini connector terry gm4dso

With LM386 the output volume should be reasonably OK. if you can use insulated mounting you could have an earphone jack wired with 56 ohm series resistor, and that helps reducing the volume into

Ken Does this mod lower out put volume? Bryan VK7KWB

Friends, I think some of what is being overlooked is the effective range of QRP under these solar cycle conditions, and the fact that most antennas are not at optimum height, and are not unobstructed.

The unused wires remain unused and can easily be removed from the plug by depressing the shiny little tab with a toothpick or paper clip wire. I had originally left them in place, but it just crowds

Craig, that is a general purpose oscillator used for other things than just measuring inductance (characterizing crystals, e.g.) The writeup is how to measure inductance using this oscillator. It

My Bitx40 arrived last week and i've been slowly putting it together. I noticed that only three of the wires are used on the 8 pin connector, with no instructions to connect the blue, orange, red,

Our limits are: above 7175 to allow US General operators to participate, and below 7120 to allow European operators to participate.? Unfortunately in North America we are getting blasted by

In the oscillator circuit in Ashhar's article at http://www.phonestack.com/farhan/measureind.html it looks to me like the 33pF capacitor is not used. What am I missing?

The main problem with 7178 is that there are spanish language kilowatt stations that are on 7175 and they are causing a lot of qsb.? W1LY had to run off one of them that was tuning up on 7178.? I am

The frequency that we used last week was very successful 7178. Yes, there was? QRM but as you all know the band conditions are not frequency specific. Moving up the band will not change anything

Sent: Wednesday, May 24, 2017 10:22 PM To: [email protected] Subject: Re: [BITX20] usb cable Hi Terry, the cable is Type Mini USb please see the image: Sent: Wednesday, May 24, 2017 9:50 PM To:

Darren, there is a third "method" out there, only mentioned in a QST (I believe) article or maybe CQ...but I am intrigued by it. The author dubbed it the "Wordsworth Method" and needs FLDIGI software:

Hi Terry, the cable is Type Mini USb please see the image: Sent: Wednesday, May 24, 2017 9:50 PM To: [email protected] Subject: [BITX20] usb cable my kit has arrived i have several usb cables but none

The USB cable needed is Mini, it has triangle type edges, not rounded like the Micro. Much more definitive in which way it goes in. The Mini in my opinion is much better? You got to have one laying

Hi Terry please read the Wire Up entry on the menu of Hfsigs.com: a.. Solder the 0.1uF disc ceramic (marked as 104) between the yellow and violet wires on the tuning pot Sent: Wednesday, May 24, 2017

my kit has arrived via royal mail - no charges it was ordered on 13 May and delivered on 24 may so fairly prompt moral of this story is do not use dhl snail mail is better terry gm4dso

my kit has arrived i have several usb cables but none of them seem to fit the nearest has the same size overall but the pins look different what is the correct nomenclature for the usb cable and where

my bitx40 kit has arrived. I have checked the contents against the list and there is a 0.1 uF cap (wire ends) which is not listed. yhere is also a smd cap listed which i think that i have identified.