¿ªÔÆÌåÓý

  1. BITX20
  2. Messages
Single Messages Topics Expanded Polls

Re: shop.kit-projects AGC board. Seeking install instructions

 

Many thanks, David. It's all working. I *do* notice a drop in overall volume.

Just an FYI for your documentation: You indicate that the S-meter connection on a TSW Teensy can go to pin A19. There is no "pin A19." There is a pin 19 which is A5. Using A5 doesn't work. The TSW documentation says it should go to A7. It also says it's pre-calibrated for the N8DAH board, and I have to assume that board is the same as yours, and if it's not I've connected to A7 anyhow - mostly because I don't have a 50 microvolt signal for calibration.

All good here. Again, thanks.

73
Dan?
AG7GM


--
Dan D'Eon
AG7GM
Join [email protected] to automatically receive all group messages.