I downloaded a new copy from and that fixed it.?
Will look at your suggestion but it's working so may moot
The first line is in the sketch but not the second line. Send frequency to chip. Don't think it is needed
Thought?
Art
Sent from my iPhone
toggle quoted message
Show quoted text
On Aug 8, 2017, at 2:12 PM, Jack Purdum via Groups.Io <
econjack@...> wrote:
OK. It seems some idiot removed a line from the code that might make a difference. (OK...it was me...) In loop, add the yellow line:
? ? ? encoderDirection = 0;
? ? ? DoRangeCheck();
? ? ? sendFrequency(currentFrequency); ? ? ?// Send frequency to chip
? ? ? ShowFrequency(currentFrequency, 0); ? // Update display
I think I removed this when I removed some debug statements. Let me know if that helps.
Jack, W8TEE
David, Jack,
Did you have an issue with vfo out? ?I installed this morning and I didn't have any output on the vfo out pins. Moved to out2 and had a signal. I thought maybe I had a bad ad9850 or u2 amp but when I reinstalled ?v1.03, normal operation was restored. Puzzled as to what is the issue ?
Art
Sent from my iPhone
On Aug 8, 2017, at 11:48 AM, David S via Groups.Io <
dcsuk10@...> wrote:
Hi Jack
I thought you should know about this.
I've been waiting for the socketed wires to connect to the board, they arrived this morning. I had your Analyser code installed in the Arduino, hooked up the rotary encoder as expected if worked OK. ?When I Installed the B40 1.05 code the encoder dosen't operate correctly, looking a both codes different pins are defined in V1.05. ?When I look back at your earlier versions of the B40 codes they are the same as in the Analyser. ?Redefining the pins sorts it out.
Regards
David G8DJM
