I have meanwhile updated the code so that the display now shows the actual
frequency during both TX and RX.
Will be included in the next version v1.14, along with some other
improvements - to be released soon.
73 Allard PE1NWL
toggle quoted message
Show quoted text
On Wed, May 31, 2017 02:07, Jerry Gaffke via Groups.Io wrote:
I have no idea what commercial rigs do these days. ??But I'd think that in
all cases the display should show the transmit carrier frequency whether
transmitting or receiving. ?? (The carrier is suppressed when in SSB mode,
but the carrier is still the frequency that gets displayed.) ?? ?? The vfo
would have to move to one side by an amount equal to the sidetone
frequency (as set during configuration) when receiving in CW mode. ??
Which side it gets moved to is determined by whether we are in UCW or LCW
mode. ??Of course, Receive Incremental Tuning can be used to adjust the
vfo further during receive. ??I'd prefer that the main display always show
the transmit frequency, but with an RIT delta frequency shown in the
bottom line of the display if RIT is enabled.
??
On Tue, May 30, 2017 at 03:53 pm, Allard PE1NWL wrote:
So the actual transmitted frequency is indeed a few hundred hertz off
the
dial frequency as shown on the display. This may be confusing for some.
I
will see if I can improve this in the next version so that the dial
frequency is updated during TX (same as in some commercial rigs).
Allard PE1NWL