开云体育

Hi, Rob Torroids, magnet wire, diodes bat41.

Hi Geoff, Thanks for the link of the box. My plan is to put it (100W version) on one 2U rack. I trying to figure out if the Hermes Lite 2 will do SO2R or I need to HL2's. I will run yagis from 50MHz

Hello Germán, You can just connect the two RX/TX pins on the ATU-100 board directly to the TX/RX pins on your Arduino. There's no need for the RS232/TTL adapter. Programming the PIC isn't more

Nuno, You can get the 1000W one is this box from Aliexpress, it all fits in rather neatly, and the box is pretty good quality. I have mine with the 1602 display in it.

Hi David, What about the -6 mix ferrites?? They are 0...55MHz rated, and other than 8.5 vs 10 relative permeability they look to be a drop in replacement.

Hi All. Just a quick question about the hardware: What chinees components would you replace while building a new (well, it's about 3 yrs old now) atu100? Cheers Robert ?Get BlueMail for Android

Hi guys. I tell you, I want to install an Arduino nano with an Ethernet shield in the same ATU1000's box to be able to monitor my remote radio station. Initially I had thought of using the same I2C

Another question, it's possible to have a 3.5", 5" or 7" display, or just the 16x2 and small Oled?

Hi David, Thanks for the info,? I think I've found it here ?ATU-100 upgraded ATU-1000 ATU1000 ATU-1KW Automatic Antenna Tuner 7x7 – New DIY Tech? this is the ATU-1000

Hi, Roger 50MHz frequency requires air core coiles with silver plated wire. An other way - use resonant antennas with no tuner, for that frequency it is very easy and not expencive due to short

Hi, Nuno ATU-100 board is 120x62mm

The code is at: https://github.com/edsonbrusque/ATU-100

Hi guy's, Can anyone tell me the size of the PCB of the 7x7 100W and 7x7 1000W. And what size are the enclosure of both, can't seems to find the info at all. I've yagis from 50MHz to 7MHz so it seems

Hello David, I'm just using one pin for TX and another for RX. It can be any pin as serial communication is handled in software in an interrupt. Code excerpt below: // cross_compiler.h #define

Thank you JM, I will give that a go. 73 Pete.

Interesting.? I tried to use the display I2C to achieve this but gave up because the display did not respond only to data addressed to it.? In the end I added a second I2C which acts as a slave to a

Hi. The same problem. In my case, solved re-solder all the relay's and coils. JM El sáb, 2 mar 2024, 19:29, Peter - M7HRL <petersheldon49@...> escribió:

Just a correction. The code I changed is the one ported to MPLAB+XC8 from David WA1RCT. https://github.com/WA1RCT/N7DDC-ATU-100-mini-and-extended-boards

Hello guys, I changed David's N7DDC firmware for remote operation. I stripped the I2C / LCD functions and replaced it with serial communication. Communication can be made via EIA-485, using cheap