¿ªÔÆÌåÓý

I am trying to set up an ATU-10 by modifying the firmware to set the min tuning power to .4 watts, set the Delta SWR to 2.0, and set Auto mode Off. I have modified the firmware hex file, recalculated

Bill, How do you use that extra board with the 40 pin ZIF socket (jumper settings etc)?? I have not found a use for that on mine that actually works. Thank you. Jim Pruitt WA7DUY

I bought this one and it works well with MPLAB IPE version 6.20 software. ?I used 4.75 volts for the 16F1938 PIC. https://www.ebay.com/itm/331901057989?_skw=pickit

/g/ATU100/files/PicKit%203%20Software/PICkit3%20all%20v3.10.zip

Hi Steve, I¡¯m using a Pickit 3.5 obtained from AliExpress, works fine! (I¡¯ve got now 3 of them) Ali may be cheaper. You will have to install the Pickit sw on your Windows pc and update the

looking at programmers on Amazon, is the ones to look out for, It looks like there are clones of the original Pickit 3 , how can I tell the difference , or is there a better place to buy one. thanks

thanks, I will have a look. VE1SK

hi Steve, for a little help look this messages/ topics: the post /g/ATU100/message/1994 to see how to program, the post /g/ATU100/message/2277 (

I just received my ATU-100-0A for my IC705, even at 10w , it will not tune. Yes I have external power on the 705. I have tried the tuner on my FT891 and it tunes fine even down to 8w. I understand

Hi Gabe, I¡¯m using the ATU-100 icm an IC705, 10 Watt Output. The IC705 has a tuner socket which looks at tuner power-on before providing a tune command. The ATU must already have power, if not, you

Unfortunately it is impossible to do that in this tuner.

Hi Nanko, Are you using the said adapter with a 705? ?By reviewing the schematics on the seller's site, it only provides a bit of level shifting. Contains no other logic that would address

AliExpress sells an adapter for the IC705 to combine with the N7DDC ATU¡¯s, i¡¯ve a few of them, works fine! AliExpress: €7,69 Adapter Board for Icom IC-7300 ATU-100 Automatische Antenne Tuner

Hello No, you have to turn it on manually every time after the certain period. You can change this time in the firmware, read the GitHub readme. But I think it is possible to do, waking up when

Hello, Recently bought an ATU-10 on AliExpress, running firmware 1.6. It works well with the IC-705, except for one issue: when the ATU-10 goes into power-off mode after being inactive, the

Bill, The Trx SWR should be close to 1 with a 50 Ohm dummyload at the ATU Ant connector. So imho there must be a short or open connection between the ATU Trx and Ant connector. Maybe try with an

Mine only had 9 turns on it. Bill

Have the tandem match unwound at the moment.? Going to have to round up some wire. Bill

The SWR was high.Bill

hi Bill, I don't know what case on your AT, but I've seen many ready built ATs with 11turns on the core... Perhaps also yours. So you can reuse the wires... You only? need 10 turns! that makes abt