开云体育

Yes

Was hoping to confirm both of these vias/pads are the same?? Both are the ANT out center pin?? I want to solder the additional SO239 pin to the empty via that is not in use by the SMA adapter....?

Hi Aaron. Care to share what you did to fix this issue.Or where you found the fix. I am having the same problem.

Matěj, Don't have an answer for your question, however I use the "Click2Tune" kit from SOTA Beams with an ATU-100 and it works well. The schematic is available online, it is a simple circuit and

It looks like a useful thing, and I understand that it's supposed to link the IC-7300 to the ATU-100 so that you can use the "tuner" button on the transceiver. But the schematics for that expansion

Ok great, Thanks Dave

I have the 1:5 windings on the transformer, but am still waiting for a pickit programmer to come in the mail.

Hi Have you done the low power tune mode Software change so it will tune at lower power and remove 5 windings on both sides of the transformer, Dave

Thank you Dave! I didn’t think it would matter, however I didn’t want to mess up the circuit design or performance. ?2 connectors will also avoid using adapters for converting sma to so239. ?I

Yes that would be fine If there is a miss match it will just tune it, I just removed my sma sockets as I am going to put BNC sockets, Dave

Can I just solder an additional SO239 connector to the pcb where the existing sma jack is? This is on the ‘out/ant’ side. ?I would like to be able to choose between sma and SO239 output jacks to

Hi John Is there any chance you can post these photos of the original board wireing Thanks Dave 2E0DMB

Previously I think the switch shorted or grounded a resistor. I tried to copy these connections across to the new board but I didn't get the same behavior as before. Maybe a minor revision of circuit

Hi John Thanks for getting back to me Yes i would put a switch on the battery wire, how was it done before ? Thanks for the info, i have just cut out the front panel of my case for a large display,

Hi Dave I don’t recall any RF noise with the old setup and as of yet, I have not re-wired the new board back in successfully. I did try and wire it in using the same setup as before but

Hi John can you please tell me do you get much RF noise with this Board, as i have just ordered one to go with my ATU-100 that i plain on using with my clansman prc320 radio and my X6100 when using a

Hi YO8SEP I know it has been some time how did you get on with this, i had the same problem and it was the diodes that had been fitted had to be changed to BAT 41, when i put this info on Davids's git

@ David: your'e so right! I forgot... (by the way: thanks for fine work!!) @ Amanda: and now from PC I add some pictures: The connectur at the pcb (regard the colors!) PIC-3 and his conector How

Hi. Pin 1 is very important to programming process.

hi, you need to connect VCC GND DAT CLK are pins 2, 3, 4 and 5 of pickit 73, Immo