开云体育

With the unit in simple "Test Mode", I am experimenting with manual operation - so, basically to perform the tuning the same as the Autotune function, but doing it manually. However, I'm not sure

.....and I have Glenn's V1.3 boards (about 10) available in the USA for $5 postpaid in the USA. 73 Kees K5BCQ

I have the V1.2 boards available ex UK

OK Luca Good luck with the project. Glenn vk3pe

Hi Glenn, thanks for your very detailed answer ! I have purchased two evaluation boards at mouser. I have seen that only few are still available. Have a nice 2022 Luca

Luca I take it you are building one of N7DDC's original PCB's??? That part is in very short supply as you have found. I don't know where you might find them. Mouser (Cat # *579-DM164142* ) have an

Hi, i ask if someone knows where it is possible to purchase?PIC16F18877-E/MV for ATU-10. 73 Luca IK2LRN

That's great - thank you for this awesome tuner ! 73, Dave KG7WOC

Hi, Dave The power measured at the input and the value is correct when SWR close to 1.

Hi - I have a question about the displayed data - With the unit in "Test Mode", the display shows "SWR" and a power value - is this value the power measured at the input to the tuner, or the output

Thanks all! Didn't know that the v1.3 would work too. Good info! Did find a v1.2, so all set for now. 73 Mark AJ6CU

By the way, Mark 0603 parts will fit on my 0805 pads on V1.3x boards. Glenn

Mark You could resolve it by fitting a separate USB socket. eBay has for example a little PCB that has a USB-Micro socket on it. Then wire it in.??? I know that won't be super easy either but would

I have one. $5 including postage

Hi, Might have messed up my v1.2 board while trying to solder the USB-C socket. So I am looking for a plan b.? Since I have already bought all the smaller SMD components, prefer to stick with v1.2

They use the ground GND in common. <djcompton73@...>于2021年12月28日 周二09:32写道：

Hello! First of all - thanks, David, for this awesome project! My attempt is about bettering the ground at the RF-power part of the board. Originally it is too much cut-through, forcing more

https://m.youtube.com/watch?v=6am8usWHHjo https://m.youtube.com/watch?v=bcwcDPU5PLQ&t=52s <djcompton73@...>于2021年12月26日 周日22:17写道：

Thanks for responding and the explanation. I will start playing with it today. Gregg KD1MU

Perfect, thanks! That was just how I was going to install the caps. Can I ask, is that an assembly video you took screenhots from? If so, I would love to see the video! I would also appreciate seeing