Well Paul, we can't exclude other possible issues being present
but if you look at the circuit schematic it clearly shows the
bodies of the input and output? sockets being connected to the
ground of the pcb. Without that your circuit is incomplete and
can't be expected to work.?
In addition, assuming that by some miracle, the antenna was
coupled and it was say a half-wave dipole, you would only be able
to use one quarter wave wire. Connect the grounds and see how it
performs.
Bill, VK1MX & VK7MX
Bill, VK7MX
On 14/03/2024 1:07 pm, paul larner
wrote:
toggle quoted message
Show quoted text
Hi bill,no it was a kit so was an oversight by me,i just wondered
if that would cause the no responce to rf or if its a firmware
fault etc.
