开云体育

When I was joined it only showed 1 person in the group. ANSRVR will drop people after no activity after a set time which I think is somewhere between 8 and 12 hours. KB3KBR Greg. Sent from my

if i send a message to ANSRVR "CQ LIVCO TESTING" it says it was sent to 2 people, but no one gets it

i got your message but i can't see the group messages

internet is working and enabled, i got the message

Just sent a message to it. Does your instance of 32 have an rf port enabled and in range of an igate or is your internet side enabled for messaging? KB3KBR Greg. Sent from my Samsung Galaxy

it works correctly under aprsdroid on my phone

i joined via ANSRVR several people are on RF and ANSRVR

Is this an ANSRVR group or a radio group message? KB3KBR Greg. Sent from my Samsung Galaxy smartphone.

yes several people

Is there anyone else active in the group? Robert Giuliano KB8RCO

I am able to join a group "LIVCO" however, i am not getting any messages from the group, and when i send a message to the group it sticks on pending

What "built" should I have? I am showing, 2020/05/01 21:21. I have been off APRS for a while. Keith [email protected]> wrote: -- Keith Boyer

if anyone is still getting the prompt message about looking into the new version to upgrade the program, it was painless and worked great.... kind regards,Brad Ko6kL

Thanks John. Tim KB2MFS [email protected]> wrote:

That is from 2016.? There were 4 software releases since then. Use this location: https://github.com/wb2osz/direwolf/tree/master/doc The original APRS protocol specification, affectionately known

Thanks James. I certainly want to convey accurate information and not "brag" about the digi. I don't think it's brag worthy as we dont have access to a real nice, high location. Our area is also

Since APRS is designed to provide information to the other operators in the area in an attempt to help everyone understand the capabilities of the local APRS network, stop and think about what

You beat me to it.... Yes, dBi. If anyone else is looking for the other pbeacon settings, it's on PDF Page 87 (printed page 80 )

Well looks like I finally found my answer after digging for quite some time. The antenna gain is specified by using dBi. Not sure why the reference of dB is used...... Back to monitoring. 73, Tim

Greg, I am looking to get the PHG circle correct on the maps. I am setting up a Digi using direwolf. In that configuration the example given does not simply use a code as is suggested by Bob at the