Re: Installing an Olympic Wave 3 Catalytic Heater to An A-frame Trailer
One other thing to consider with catalytic heaters is high altitude, they don't work too well over certain altitudes.??
Mr Buddy heaters aren't guaranteed to work over 7000 ft, per their
By
dan smartt
·
#104486
·
|
How to install lift assist bar around wind cheater
We have a wind cheater strap on our 2004 DL Aliner. Now, we would like to add a lift assist bar. What should we do to make everything fit?
By
Laraine Hutzell
·
#104485
·
|
Need recommendation for aliner cover
We have a 2004 DL ¡ª15 ft Aliner that needs a new cover. Does anyone have a recommendation?
By
Laraine Hutzell
·
#104484
·
|
Re: Installing an Olympic Wave 3 Catalytic Heater to An A-frame Trailer
Brian, don't you get a lot of condensation with a catalytic heater?? You're venting exhaust gases inside the trailer, and some of that is water vapor.? I run my stove to cook in the morning to make
By
Steve T
·
#104483
·
|
Re: Issue with Tire Size
You have a ton of excess capacity in 15" tires.? Going from a 235 to a slightly narrower 225 will not cause any capacity problems.? If anything, 225s would be better because they'll get a little
By
Steve T
·
#104482
·
|
Re: Installing an Olympic Wave 3 Catalytic Heater to An A-frame Trailer
Thanks for this heads up, its a great price. It'll be nice for next fall/winter camping.
By
patternman
·
#104481
·
|
Re: Issue with Tire Size
I've had good luck with Carlisle Radial ST Load Range D tires. My
wheel size is 13", but they are available for 14" and 15". The
Endurance tires are not available in 13". Also, Hercules tires
By
elegy3983
·
#104480
·
|
Re: Storing up or down?
Thanks for the advice.? I was leaning that way.
By
ConnieM
·
#104479
·
|
Re: Installing an Olympic Wave 3 Catalytic Heater to An A-frame Trailer
It is still at the huge sale price of only $234 at Camping World.
By
Brian Hovander
·
#104478
·
|
Re: Installing an Olympic Wave 3 Catalytic Heater to An A-frame Trailer
It is just the generic "Wave 3" model that produces either 1600 or 3000 BTU of heat (no need for battery power).? Someone was selling their Aliner due to issues like no heat when the battery went
By
Brian Hovander
·
#104477
·
|
Re: Storing up or down?
Hi Connie:
We store ours up in a shed with a dehumidifier. I don't fully latch the roof to protect the roof to wall sealing foam.
Carl.
By
Carl
·
#104476
·
|
Re: Issue with Tire Size
The Goidtear endurance are a good choice, much better brand than the stock tires.? A little less surface area 10mm on the road shouldn't matter and technically will give less road resistance.? The
By
dan smartt
·
#104475
·
|
Issue with Tire Size
Hi,
My 2021 Expedition Offroad came with Klever A/T 235 75 R15 tires, Load range D1 - 65 psi max, load index 110/107.? I am at the 4 year mark and am going to replace these tires.? However, when I
By
Steve S.
·
#104474
·
|
Re: Storing up or down?
I store my aframe inside my garage, in the up position. I believe it's less stress on the springs and it makes it convenient to get in the camper. Etc..
If I stored it outside - I definitely would
By
dan smartt
·
#104473
·
|
Storing up or down?
I've seen some conversation about storing the camper up vs down.? We have a boat stall for the camper, but I was wondering what everyone on here recommends as far as raising the roof panels or
By
ConnieM
·
#104472
·
|
Re: Installing an Olympic Wave 3 Catalytic Heater to An A-frame Trailer
Here it is at Amazon for $310
https://www.amazon.com/Camco-Olympian-Wave-3-Catalytic-Heater (
By
patternman
·
#104471
·
|
Re: Installing an Olympic Wave 3 Catalytic Heater to An A-frame Trailer
Here is a link to the Camco website. https://camcooutdoors.com/olympian-wave-3-catalytic-safety-heater-3000-btu/
By
Eugene Breindel
·
#104470
·
|
Re: File /2021 Aliner Owner's Manual.pdf uploaded
#file-notice
Do you have a photo of a better approach? Thanks.
By
jdmv12
·
#104469
·
|
Re: Installing an Olympic Wave 3 Catalytic Heater to An A-frame Trailer
Looks like a well thought out installation but you have added several more gas connections that will need to be tested with a soapy solution after every move. To me that's one of the most annoying
By
dsmithsota@...
·
#104468
·
|
Re: Installing an Olympic Wave 3 Catalytic Heater to An A-frame Trailer
Very interesting Catalytic Heater installation, Brian. Can you post
the mfgr, model number of the unit you installed? Thanks.
Dave
By
elegy3983
·
#104467
·
|