开云体育

You need a battery for the trailer emergency brakes in case the trailer becomes disconnected while towing. That's the only reason - a battery is really necessary - you could? just get a small battery

Do I really need a 12v deep cycle marine battery or any battery at all for my 2022 Scout Lite? I rarely boondock. And I have rechargeable puck lights and two rechargable fans for air movement?

I had this and determined it was from the hinge rusting up.? If you use your camper during cold weather the condensate drips right down into the hinge and the amount of rust can be impressive. I

In this podcast I interview ALINER CEO & President Brett Randall. The podcast focuses on the new Evolution model, but shockingly Brett announced the introduction of a brand new camper which is the

You probably needed longer gas springs of the standard 26" length and at likely 40 pounds rated force (when extended).? this would give a longer moment arm and more force.? That would give 73% more

From what I have seen, it is simply a length of square aluminum tube.? Have someone check a local aluminum distributor.? Very affordable compared to a box store. -- Don DeRyke Sunrise, Florida 2009

My dometic is slightly different, but I removed the top shelf, and there are some recessed openings where a stopper may have been.? I looked up you model and the manual does not mention the shelves

I think the hinge separation you're seeing is caused by the 100# gas springs, not the 30#'s. Try removing the 100# springs.?Repair your piano hinges with 10-32 stainless steel bolts and nylok

Is it possible to remove the stoppers so I can take out the fridge shelf? Don't want to break them if they are not removable.

I've just been notified that one of the wind kit arms on my 2016 Aliner Ranger 15 has been damaged. ?How do I go about replacing it? ?I'm not in North America right now so don't have it in front of

I inadvertently started a new threat on this.? ?It must be because I changed the subject name and put the word update in front of it.

Hello: We don't have struts, but I found the pop rivets giving way. I put a 1/4" bolt between all the rivets and extras at the ends. Very stable now. Why did they use pop rivets in such a high stress

I bit the bullet and finally mounted two 30# gas Springs on the front section. I like them, they are mounted at 72° when open.? They don't quite provide the lift needed to make them neutral.? As

hi gang: we had a bearing cap with a zerk and I pumped grease in before each trip. the bearings were always almost too hot to touch. the break mechanic cheched them and said "too much grease" and

Might the hot side been the sunny side while traveling?

That's just scary...? That entire axle is trashed...?..........?One way to know the hub is too hot is when the orange light comes on.

You mean "ballpark" max temp? Nothing official that I know of. Normal hub temps are usually about 150 degrees F. or less. 200 degrees or more would concern me.?Dave?...........??Is there a

Nothing. To read hub temps with a non - contact infrared thermometer, the hub has to be exposed. I recommend removing and discarding wheel hub caps, so the hubs are always exposed.?Dave?..........

One way to know the hub is too hot is when the orange light comes on.

This raises a question for me.? What do you have, if anything, covering the hubs?? I would have to remove my wheels to check the temp.