开云体育

The propane fridges draw 14 amps in DC mode, but only 400 mA when using propane. A compressor fridge of the same size as our 3 cu ft propane fridges burns about 30 amp hours at 77 degrees in 24 hours,

Unfortunately the comment about clean with alcohol was referring to surface prep to remove oils and other dirt on the area to be sealed.? It doesn't mean alcohol removes silicone.? The reviews of

I was browsing also. The remover believe you were thinking of is digesil. It's very expensive. Alchol sounds better. There is also so.ething called kleen strip that has 50/50 reviews.

Kathy, It's interesting.? I was just on GE Silicone's website.? They have a video about removal.? They use isopropyl alcohol for clean up.

No dormers, thanks Don. [email protected]> wrote:

Kathy, The width should not make any difference.? If you have a dormer like my Classic, the roof seal sits on top of the dormer hinge, and the hinge seal is under the hinge and acts as a gutter.

Hi all, I'm talking about the flat, wide piece of foam that goes across the back panel. I ordered it from Aliner ( ridiculous price, but didn't feel like searching). The piece they sent me looks to be

Alignment is huge. I had to slot the mounting holes 5/8 inch to get alignment to hitch and prevent rubbing at front of wheel wells. But after 10,000miles, tires were lumpy due to belts. Found the toe

And the only issue with compressor fridges vs. absorption/evaporative units is that they require AC or DC voltage to work: they won't run on propane.?Dave.......?And there is the major problem with

My alignment was off by 1/4" from the factory which made the tires wear out rapidly.? I unbolted the axle from the frame, did some filing, and was able to get the axle aligned to have the distance

And there is the major problem with evaporative type refrigerators. My Dometic pulls 14 Amps continuously. That's way over 150W all the time. My new Alpicool compressor type cooler pulls 2.5 Amps

You would need a lot of batteries to run a refrigerator for a few days, at least 300 Ah. Lead-acid batteries would be way too heavy for an Aliner, and Li-ion batteries would be extremely expensive.?

Richard :When I spec'ed my 3500# axle, I found that it worked well under my 2500# 2005 LXE. The GAWR rating is just a matter of how much rubber Dexter provides in the axle tube, and has little bearing

Thank you for the link. It was a very helpful article! After reading it I decided that I did not want /need a 3500lb axle after all. I don’t carry that much weight and having that axle may cause

This is inaccurate. Dexter makes a wide range of torsion axles, many of which are compatible with Aliner frame mounts. Check their website for

Thanks to all ! [email protected]> wrote:

Lol. We get truckers stuck in our development all the time because of bad gps directions. wrote:

Thank you for the information, I do appreciate it. D. Soldressen Ambridge, PA

Typically you would buy a new 3500 pound axle direct from Dexter which will fit most Aliner campers. I bought mine from New Era Parts. A hint : buy your new axle with 10" electric brakes and hub-drums

Aliners typically have torsion axles. Dexter doesn't make a torsion axle, as far as I can tell.? If you want to convert over to leaf springs, a shop will have to weld on the axle hangers. You can get