开云体育

The clearance issues on a trailer tongue come into play because of the distance between the trailer wheels and the TV wheels. Like when you are pulling into a driveway with a short steep apron. (I

I am afraid I have no knowledge of the awning you are speaking of, but I have seen a Rockwood high wall with the same type of screen room built for their brand in use by someone. It might give you

Thanks Don!

15" of clearance when connected, the trailer axle is only 12" & I don't off road so I think I'll be ok On Thu, Feb 15, 2024 at 6:37 PM, Don DeRyke via groups.io<DERYKED@...> wrote:

Dan, what's your clearance to the ground when connected to the tow vehicle?? I clipped my jack once going into a gas station.? It was all the way up, and the wheel removed. I think Carl had a great

Thanks everyone for your input and solutions,? I went ahead and mounted the spare under the tongue using 3 - 1/2"x8" bolts (2 through the stud holes and the last one centered with a metal plate

Do to a partial failure of my rear bumper on my 2009 Classic, I reinforced it with welded collars, and installed an independent receiver welded to the frame with two cross members.? I moved my spare

Jackie: I have seen posts about this awning.? Unfortunately I'm not sure which Facebook group it was on.? I'll see if I can find it.?

Hello folks!? I am wondering if anyone has experience with this awning.? It has a big 'Aliner' tag/label that would be front and center when the awning is up but we can't find any pictures or videos

Hi Dan: I had a spare mounted under the tongue for years on my 2005 LXE. The spare was located between the rails of the tongue, not under it, so there was little road interference. In order to

Hello Dan: We have our spare in back, but it is supported by a brace inside the back wall. Only the vertical weight is on the bumper, no torque. Carl.

If you have the regular model Aliner I doubt you could put a spare anywhere under the trailer.? If you have the off road model, some have bought one of the under trailer spare tire carriers, mounted

I would be concerned about ground clearance especially when hitting steep driveway aprons. My driveway apron is steep enough that I couldn’t back in with the spare mounted on the original bumper

Greetings all Did a couple of long trips with the aliner this year. In January went around Arizona & a couple of stops in New Mexico.? Arizona roads are pretty rough (I'm talking about the

I made the mistake of using the door side wind bar on my ‘22 Classic as a mounting point for a small triangular canopy. The wind bar mount pulled out of the roof when it got windy. The top of the

? 2017 Aliner Scout Lite - $9300 , $8800 FIRM ?? (Price reflects new battery and professionally installed brake controller) You can view video & pictures at

Sure, there are uncertainties due to connector resistance, etc. Ohm's Law quite accurately predicts the wire loss.

There's some guesswork using math to calculate the amps in the wire.? ?It's hard to estimate wire length and thus voltage drop for the path from the TV battery/alternator to the dc charger in the

Renogy specs the efficiency as "up to 90 percent". However, the input voltage can be a slow as 8 V. So, charging a battery at 20 A and 13 V from an 8 V source at 90 percent would be 36 A. You really

Scott, You did what I was contemplating for installing the dc charger.? Just cut the white and black wires coming into the trailer from the bargman cable, connect the TV side of the wires to the