开云体育

I have use them one time and they are great. They lot of little things that are hard to find. Ebay is like old west and try to avoid Ebay but have will throw dice ?. Remember they not like Amazon

I did not know about that resource - thanks.

Now that it's been overcome by events, don't forget LMS has a good troubleshooting guide: < https://littlemachineshop.com/info/business_resources.php?ID=1343147195&CAT=1 > Roy

I am glad was simple fix. Dave

Hope to see photos of work. Dave

I have made wooden fixtures using "T" nuts and a center spud to mount stuff to a face plate. John Mattis [email protected]> wrote:

Often, there are ways to get around some limitations.? A possibly easier setup than the faceplate is to bolt the flywheel to something smaller and then chuck that something into the 4-jaw.?

All, Thanks for all the suggestions. The flywheel has 4 big holes so I will drill the holes out and mount it on my 4 jaw scroll chuck as suggested by davesmith1800. Hopefully I can get it turned on

??? Look at it this way , ya were just testing the emergency switch which a guy/gal should do every once in a while & it passed . Glad i was something simple . yea that's it animal

Problem solved.? It was operator stupidity.? I had pushed the emergency shut off button down before I replaced the fuse.? Forgot to open it back up.? Argggggg!? Oh well, at least I didn't start

??? Unplug the machine , label all the wires to the board & double check a few time than pull the board & start looking for burnt components & give the board the sniff test . Sometime yer nose can

ya could pull the motor & hook a volt meter to the leads & spin it with a drill & see if ya get any voltage out . I'd try to see if it spins with a tool battery first . animal

Yes, that's the lathe.? Pulled the brushes and they are both about an inch long - I'm assuming it is not the brushes.

Replaced fuse.? Motor still won't turn on - new fuse didn't blow.

??? I believe ya can test the motor by hittin it with a good cordless tool battery . Are these boards SMT or they still through-hole ? boards ? animal

If anything is “blown” it is most likely one of the MOSFETs on the motor controller PCB and not the motor. It costs about a buck to replace if you can DIY, or more like $100 to have someone do

? ??? Is this the lathe https://cdn0.grizzly.com/manuals/g8688_m.pdf see page 39 ??? animal

Does the fuse blow as soon it given power? It could different problem not the motor. Dave

I done for cast iron wheels also used a draw bar through spindle. Dave

Had a crash awhile back while using a milling bit on my Grizzly 7x12 mini lathe.? Motor stalled and fuse blew.? I put in a new fuse, but motor won't run.? Are there any other circuit breakers/fuses