I am glad was simple fix.?
Dave?
toggle quoted message
Show quoted text
On Wed, Jun 12, 2024 at 09:59 PM, Arthur Coe wrote:
?
Problem solved.? It was operator stupidity.? I had pushed the emergency shut off button down before I replaced the fuse.? Forgot to open it back up.? Argggggg!? Oh well, at least I didn't start full scale disassembly.
?
On Wednesday, June 12, 2024 at 08:16:22 PM PDT, mike allen <animal@...> wrote:
?
?
??? Unplug the machine , label all the wires to the board & double check a few time than pull the board & start looking for burnt components & give the board the sniff test . Sometime yer nose can find the bad part .
animal
On 6/12/24 7:53 PM, Arthur Coe wrote:
Yes, that's the lathe.? Pulled the brushes and they are both about an inch long - I'm assuming it is not the brushes.
?
On Wednesday, June 12, 2024 at 06:56:57 PM PDT, mike allen
<animal@...> wrote:
?
?
? ??? Is this the lathe? see page 39
??? animal
On 6/12/24 6:18 PM, Arthur Coe wrote:
Had a crash awhile back while using a milling bit on my Grizzly 7x12 mini lathe.? Motor stalled and fuse blew.? I put in a new fuse, but motor won't run.? Are there any other circuit breakers/fuses that could be the problem?? Or, am I looking at a blown motor?
?
?
davesmith1800