开云体育

THESE? MAGNETIC? SYSTEM? ARE? DIFFICULT? TO REPRODUCE the mag? have? to? be? in? the? exact position for? his polarity? ?orientation if? you? mark? both? mag? for? the?

I have order from LMS? but never take phone. Good to know they are very helpful on phone Thank for review Dave

I do not know. I told about when asking questions about rebuilding a magneto back in 1972. Dave

I should of taken more pics. The only ones I took are of the control box wiring. The tap from LMS held up well, but the 2.5mm drill bit didn't. Tapping the holes was very easy. Perhaps using the Tap

Why would taking it apart lose most of the charge? sbcglobal.net@groups.io> wrote:

There are/were lots of discussions about the rear slide plate some time ago. On larger machines, setscrews through the slide plate are a common means of adjustment - on these relatively small

Like photo As metric goes I have all taps in inch. So I pick a inch tap close to metric thread size. Like 6M I use 1/4NC Sometimes I have buy a metric? tap so today I 10MM x 1.0MM LH and one 12M

Thanks all for the replies. I'm going to take it a little slow reassembling it. I did install the rack today and managed to break the LMS 2.5 mm drill drilling the first hole. So, I used a #40 drill

Congratulations, Johannes, it is always good to see posts like yours! Bill in Boulder,CO

It depends on the magnetic. Like a magnetic chuch there most have a charge magnetic.? If take the chuck apart the magnet will loose most of charge. Do not buy use magnetic chuck unless check

Any photos you could posted Dave

I've done it, and it's a pretty straightforward project.? Just take your time.? I know they say it can be done quickly, but I took my time and did it over 2 days.? The instructions are complete,

Heh - wrote Take Pictures but you are already reassembling. The written instructions are lacking in a few areas. Watch how the gears go inside the gearbox. Hopefully you have plenty pf pictures. Make

Hi folks. I have to express my feelings: After 10 years, nearly everyday in use, my LMS 5200 lathe motor had to be replaced. Still running, however , noisy. I order a new one from USA. Without

The video referenced above https://www.youtube.com/watch?v=RUV55lXNBaY

I found this youtube video. At about 13:00 he describes a scratch test to tell if the slug is a real magnet or just a magnetized piece of steel - supposedly the latter can't be removed. I scratched

Hi All, After putting it off for way too long; I'm finally getting around to upgrading my HF 93212 mini lathe with the LMS 5000 16" bed extension. I have the lathe torn down. Decided to play it

FYI If pull apart the magnetic may not work. I just buy new so know what happened to magnetic. I have magnetic basics some over 60 years old the slowly lost there power over years like a

I doubt that pulling the magnet would de-magnetize it; the base was probably built by inserting a magnet into the housing. Still, to be safe, you could try softening & flushing out the old grease with

I think mrpete222 has a tube on taking them apart animal