开云体育

It is a mini lathe I have own very large lathes in my life. The mini lathe is easy to move. Dave

Moglice is one that folks have used on lathe beds & headstocks & the other parts that run on the ways . animal

Bondo to cover up? their casting bloops animal

Always bearing in mind that those ‘limitations’ my now be so, depending on the work you intend to do. Best regards David

I agree with you, Mike.? I also started with the HF 7x10, when they were around $425, and I had a 25% off coupon, so it was around $320.? I also upgraded the bed about 2 years later with the LMS 16"

There is a family of products, horribly expensive, that are a filled epoxy for restoring worn ways. Scrapable but very hard. I think that they had a product that worked as a filler to restore

Bill, Your filled-epoxy suggestion got me thinking. I wonder if what I thought was paint under the headstock was the vendor adding epoxy to correct an overgrind? It was in the right place to have

I had mine shipped to my home ? . It light enough so my self and wife could pickup and put on the table. All from Walmart. Dave

I bought a Speedway 7X12 about 20 years ago for $300. Many mods later I am still happening with it. I replaced the 3 inch 3 jaw chuck with a4 inch one from LMS. Regards John Mattis

I will just say that I bought the original HF 10" lathe and used it for many, many years before buying a longer bed kit when they were on sale from LMS. So if you find a good lathe at a good price,

they probably hang out with the cocaine bear . animal

Here's something to think about when it comes to Chinese-made machinery. They are not the same thing even if they are products from the same factory or the same brand. In china, cabbage, for example,

Following that GadgetBuilder protocol, I cleaned surfaces, applied DyKem and mated the headstock and ways, sliding them 1/8" forwards and backwards. Contact areas are left and right rear flats and

I went with 14" size Preenex? 8”x14” Mini Metal Lathe just for a little extra room . I did think of 16" too but have stop on size . I limit my decision by weight keeping under box weight 140

Got a friend with a surface grinder? Setting the headstock up with the spindle bore parallel to the table and cleaning up the base of the headstock would do wonders! The cheap way might be to use

It all in the Reindeer for flying. The Reindeer are test all time for flying. Dave

Yes - Santa exhibits quantum entanglement - he's everywhere all at once.? And if you observe him, he gets locked into a specific state.

I’ve got “The Complete Mini-lathe workshop” on order, thanks. As noted in https://gadgetbuilder.com/Lathe_Align.html bolt torque appears to be good for only 0.0005-0.001” vertical at best and

?Spoilsport ???. Seriously thanks for the calculations. Very very interesting….. However, may I point out that as he has,, in fact, magical powers eg. going into houses or apartments

Recent posts above should dispel any consideration of the 7x"10" lathe.? ?This variant, 7x10, has been so advertised for decades, and it is NOT 10", it is 8".? ? You will quickly find the use of