Re: Rong Fu Industrial Introduction
|
Seb,
??? I used two small ¡°L¡± brackets with ¡°stick-on¡± felt. They
are held in place with 4 dime sized ceramic magnets. They are free to ¡°float¡± a
little on the magnets so have never jammed up. The stick-on felt is readily
available at Lowes or Home Depot and will just peel off when replacement time
comes.
Am attaching a jpg, hope it comes through.
?
Carl H
toggle quoted message
Show quoted text
From: seb fontana via groups.io
Sent: Thursday, April 30, 2020 2:08 PM
Subject: Re: [4x6bandsaw] Rong Fu Industrial
Introduction
?
I
don't believe I've seen this mentioned..I have mounted air nozzles [1/16th
copper tube from manifold] which are aimed at the blade after it passes by the
locating wheels aft of the cut to blow the chips off the blade. Keeps chips from
accumulating on drive wheels and from getting wedged between the horizontal
guide wheels and blade sides. Especially when the saw is used vertically and/or
cutting plastics. I have a pressure regulator at the manifold, 15# psi is
usually enough. Only down side is a lap full of chips when used vertically, some
cardboard will tone that down. Seb.?
|
