Re: Rong Fu Industrial Introduction
|
John, ? As an experiment, I added an 1/8-inch thick strip of metal on one side of the top and bottom blade guide supports. ? This is the top support. On the right side, the bar is in contact with the casting. On the left side, it is jacked up by that strip. The bottom got the same treatment but it is hard to take a picture. ? To my surprise, this was enough to get the flank of the blade to be perpendicular to the saw top. ? I¡¯m a bit concerned about the added stress on the blade. Should I be? ? Thanks, ? Rick ?
toggle quoted message
Show quoted text
From: [email protected] On Behalf Of John Vreede
Sent: Tuesday, April 28, 2020 7:23 PM
To: [email protected]
Subject: Re: [4x6bandsaw] Rong Fu Industrial Introduction ? Hi Rick
Try something like this.? Packed out with washers between the casting and the adjuster on the side and the end to get the right adjustment range.
Push-pull along the joint, and just push on the other axis which I've not had to adjust so could be left out - jv
|
