Re: Ideas For Holding Copper Water Pipe Fitting
|
That solution could be employed with copper also. From: "hamholfarms@... [4x6bandsaw]" <4x6bandsaw@...> To: 4x6bandsaw@... Sent: Thursday, August 16, 2018 12:46 PM Subject: RE: [4x6bandsaw] Re: Ideas For Holding Copper Water Pipe Fitting Creative Solution Award??  The picture did not come through for me; however, I do understand your idea. I think I will try bending first, as I think it would look less obtrusive.? Thanks, Chip
Hopefully my picture comes through. ? Since this is a low pressure application, I wonder if you could use a 2¡± end cap. Drill a radially hole that is a tight fit to the pipe in the cap. Then drill the second hole at your desired angle. Use PVC cement to secure the pipes in the cap. Then use a short section of pipe and a second cap to seal it up. ? ? Rick ? ? ? ? ? ? ? |