Creative Solution Award??
The picture did not come through for me; however, I do understand your idea. I think I will try bending first, as I think it would look less obtrusive.?
Thanks,
Chip
Hopefully my picture comes through.
?
Since this is a low pressure application, I wonder if you could use a 2¡± end cap. Drill a radially hole that is a tight fit to the pipe in the cap. Then drill the second hole at your desired angle. Use PVC cement to secure the pipes in the cap. Then use a short section of pipe and a second cap to seal it up.
?
?
Rick
?
?
?
?
?
?
?
