开云体育

They have a US & Printers. The US one is fairly good (7 out 10) but the China one are 50:50. If you see images that have dozens od supports, they SUCK. Structures are hit/miss. buildings that have to

Ya get what ya pay for. 3D printed products that are marginal at best. Maybe acceptable quality...........not for me. Go with anything from Archistories, keep an even look/theme. Other will chime in

I want to get a simple preliminary layout in place (will later be upgrading quality of buildings/scenery over time.) Has anyone experience with OUTLAND MODELS? ?I was about to order a few buildings,

HELLO, HELP APPRECIATED for finding some Foam Color we are adding to a mix for Custom Trees I am making for a Layout Timberline Scenery’s LODGEPOLE GREEN GROUND FOAM COLOR or FLOCKING COLOR We

I’ve gone through two or three at this point. One time the switch, one time the potentiometer and once some phantom failure I couldn’t trace. Dexter

The directional switch on my Rokuhan RC03 recently locked up and would not move. I opened up the case and found the switch had come apart. I will need to unsolder it from the PC board and install a

By the number: 1. ?Thank you for your timely reply. 2. ?I am working with a train guy who is the group's electrical guru. ?He is designing an inline item that will cut off voltage at 11 or 12

There is a little piece that slides in to make the contact. Whoever you bought the track from will have this listed. (look in the Track Accessories

I think this may be what you need. Check Z Scale Monster

You are in need of the following. Rokuhan A008 Narrow Feeder CableBrand: RokuhanProduct Code: A008MSRP: $10.45? ? ? ? ??DescriptionRokuhan A008 Narrow Feeder Cable Be very careful with your

Hello, very new to this so: I have an MRC 1300 controller and Rohukan track with "concrete" roadbed. Some sections of the track seem to have a place to remove a bit of the plastic roadbed and effect a

If somebody can send me one, I can quickly get the technical data e.g. Waveforms (Unloaded, pure under pure resistances range) Low voltage 'Pulse-Power' Peak 'spikes' Short handling Actual running on

Thanks. ?I am getting a new in box MRC 1300. ?I am having a voltage restrictor added by a friend to hold max voltage to 11 v DC to prevent any surges or accidental over throttling. DH

Just a heads up. I am hearing multiple reports of older MRC1300s failing. Some have even damaged AZL locos due to the higher voltage output of a failed device. I would be very caution using older

Failed the bulb test and further research showed using the multimeter to test for variable voltag was the right way. ?Seller gracious & refunded $ with an apology. DH

Thanks Greg, will try that tonite. DH

My Tech II Railroad Power 1400 also reads in the range but with the logo on the track it goes virtually zero. The wiring inside shows that there are a tap in the potentiometer for speed that controls

most likely blown output transistor. just to double check, get an automotive 12v bulb (that can be sacrificed) and try it... you will know if it is constant output or not. Greg

Just rec'd a MRC1300 for my yet to be assembled Z trains (MARKLIN) Wanted to test output. Got 19.6vAC for accessories terminals. The DC output is a constant 15.6vDC, not affected by dial position. Is

Be Part Of The Next Layout Tour (So. Calif.) [Please do not hit “Reply”. Contact me directly.] Model Railroads of Southern California’s next layout tour will be Saturday, February 15. The tour