Update on Low audio:
?
From my good friend WD8DSB:
Today Mike (W9RE) and I did some troubleshooting on a YCCC SO2R box at Mike’s and found we had lost 5 Vdc on pins 11 and 15 on the MAX9722A but we had 5Vdc on pins 2 and 3. We then did continuity checks and saw something like 3 Meg Ohms between pin 2 and 15 as an example. We decided we must have had a broken trace so we installed a jumper between C104 and C107 pins that normally have 5Vdc to reestablish 5 Vdc on pins 11 and 15 and this fixed the original problem of no audio output.
?
BTW my box has a white DIP for U3 where my spare (just repaired box) has a black DIP for U3.? I am not using Icom rigs right now but should I replace it anyway?? If so what part number should I order?
?
Thanks,
?
Mike W9RE
On 12/17/2024 4:07 PM EST Mike Wetzel <mjwetzel@...> wrote:
?
?
I obtained? a spare (backup) SO2R Box+ and comparing it to my original unit I notice that the audio is say a good 6db lower when listening to radio 1 when plugged into either channel 1 or channel 2.? This is only with the radio plugged into either DIN,? 12Vdc and audio out plugged in and of course flipping the rx switch.
?
Any things I should check or buy for replacing??
?
Paul was there a chip that was universally replaced in the original buy?? I think the vintage of both units is the same.? Seems like I remember something about a green or white device that should be replaced (updated)?
?
Tnx,
?
Mike W9RE
