开云体育

never assume it needs 'finals' that's? as i quite often see a CBers diagnosis.. it could be a driver, or even an ALC problem, or power to the devices issue.. just assuming might end up fixing it,

Mark, thanks for taking the time to tell me what I should not assume and to have a dig at CB'ers ??? But you missed the point of my post, I was asking for assistance or if anyone else had experienced

I searched the group and have not found this subject.? Does the FT-920 have an RF spike when PTT is applied?? A lot of radios of that vintage do but have not seen or heard of the FT920 having

Hey Wes, i have 2 FT-920. One of them produce RF spikes (the newer one). If you set the TRX to eg. 5W, the spikes will be full 100W. The other one doesn't (the older one). So best would be to measure

Sebastian, Thank you for reply.? That is good to know information.? Could you tell me what you used to capture the spike.? I have assumed it would be too fast to record without a storage scope.?

Thats the way i measured it - with an storage scope. Currently, i have no idea about the duration of the spikes - but it was enough to kill an Amp of a friend. I can measure them again, but first i

Hey friends, i have a FT-920 which has some strange problems. When turning on the TRX with 13.8V supply, it makes strange noises and you can't hear any signal/noise. If i'm lowering the voltage to

I have been trying to get my FT-920 to operate with WSJTx. ?I am using a SignaLink USB soundcard and a MacBook Pro computer. ?I have searched the web for set-up instructions and have been

I have a '920 and a Signalink USB configured for WSJT-X. Attached are photos and PDFs explaining how I have it set for on my PC. I hope this works for you. If you have any questions, feel free to

Thanks for the info Tom. I have my radio tab set up much like yours. According to the 920 manual, the serial port parameters should be set to 4800, no parity (no provision to set parity on my setup),

As far as no messages showing in the Band Activity window, do you have your computer time synced with the WSJT-X software? Timing is everything with regards to making WSJT-X decode contacts. The two

Tom, I am using have been using the onboard time source in the MacBook Pro. I have used it for years with my FT-1000MP and the older WSJTx software (V 2.3 and previous) just fine. I have restarted

Hi Marty, I'm not familiar with the MacBook Pro. I'm sorry to say I cannot suggest what to do with your timing issues. Tom, N8EUI [email protected]> wrote: