Re: WSJTx FT-8/4 Ops on FT-920
|
As far as no messages showing in the Band Activity window, do you have your computer time synced with the WSJT-X software?? Timing is everything with regards to making WSJT-X decode contacts. The two must be in sync with each other. Meinberg and NetTime are a couple of time sync programs that work.
Tom
Thanks for the info Tom. I have my radio tab set up much like yours.? According to the 920 manual, the serial port parameters should be set to 4800, no parity (no provision to set parity on my setup), Data bits 8, and stop bits 2.? That is how mine is set.? Stop bit set to none, 1 or 2 didn’t seem to make any difference.? PTT=VOX; Transmit audio source not selectable (greyed out, shows Front/Mic); ?Mode=Data/Pkt; ?Split Ops=None.
I think I found why the TX didn’t seem to work.? The VOX button on the radio needed to be pressed.? Now I have good power control with the SignaLink USB.? So it seems to transmit OK.? The issue now is receiving
The radio receives OK and I get signals painted on the waterfall but no messages showing in the Band Activity window. ??????
I really appreciate the help.
I have a '920 and a Signalink USB configured for WSJT-X. Attached are photos and PDFs explaining how I have it set for on my PC. I hope this works for you. If you have any questions, feel free to ask.
73, Tom, N8EUI [Edited Message Follows] I have been trying to get my FT-920 to operate with WSJTx.? I am using a SignaLink USB soundcard and a MacBook Pro computer.? I have searched the web for set-up instructions and have been unsuccessful trying any of them.? Anyone have any help her. ? <inline.0.part>
|
