Well I decided to get brave and just try it. A step by step procedure to remove the VFO assembly from my FT-301:
- Unplug RCA connector on bottom of VFO
- Remove white tape from connector at back of VFO and disconnect
- Unsolder white/orange wire from red LED at the Channel switch. (note where it goes back later)
- Remove two screws on crossbar at bottom front of VFO?
- You'll probably need to remove the Filter and AM modules to gain access for the next step
- Remove screws holding crossbar at top back of VFO
- Entire VFO, gear drive & circular plastic kHz display should now wiggle out.
You might need to remove other items - I already had the small lamp bracket out and front panel off. Those may NOT be necessary.
Joel, VE6EI
Joel Weder, VE6EI