开云体育

For YAAC to receive from a group, you have to indicate you are a member of the group by listing it on the Message Groups table on the expert-mode Configuration dialog's General tab, and then enabling the group. This allows to leave and rejoin the group without having to delete and re-add it on the table.

Hope this helps.

Andrew, KA2DDO
author of YAAC

________________________________________
From: [email protected] <[email protected]> on behalf of e m via groups.io <delivers1234@...>
Sent: Wednesday, February 19, 2025 7:10 PM
To: [email protected]
Subject: [yaac-users] APRS Group messages

So I am able to send a group message by use the "To:" at the bottom via wide1,wide 2. Is YAAC capable a receiving a group message directly? or do I have to filter out from the messages.


Sincerely,
Eugene Mosqueda

Dominus Providebit

You might want to associate the MESSAGE_TO event type; that will cause the sounds plugin to announce when a message addressed to your group arrives. Of course, that's only meaningful if you are using the sounds plugin. :-)

Andrew, KA2DDO
author of YAAC

________________________________________
From: [email protected] <[email protected]> on behalf of e m via groups.io <delivers1234@...>
Sent: Wednesday, February 19, 2025 10:34 PM
To: [email protected]
Subject: Re: [yaac-users] APRS Group messages

Do I need to or should have an event type for the message group?


Sincerely,
Eugene Mosqueda

Dominus Providebit




On Wed, Feb 19, 2025 at 4:32?PM Andrew P. via groups.io<> <andrewemt@...<mailto:[email protected]>> wrote:
For YAAC to receive from a group, you have to indicate you are a member of the group by listing it on the Message Groups table on the expert-mode Configuration dialog's General tab, and then enabling the group. This allows to leave and rejoin the group without having to delete and re-add it on the table.

Hope this helps.

Andrew, KA2DDO
author of YAAC

________________________________________
From: [email protected]<mailto:[email protected]> <[email protected]<mailto:[email protected]>> on behalf of e m via groups.io<> <delivers1234@...<mailto:[email protected]>>
Sent: Wednesday, February 19, 2025 7:10 PM
To: [email protected]<mailto:[email protected]>
Subject: [yaac-users] APRS Group messages

So I am able to send a group message by use the "To:" at the bottom via wide1,wide 2. Is YAAC capable a receiving a group message directly? or do I have to filter out from the messages.


Sincerely,
Eugene Mosqueda

Dominus Providebit